Loading ...
Loading ...
Loading ...
7
LAMP REPLACEMENT
Switch the appliance off, disconnect from the power source and give
it time to cool off.
Press the face of the light in slightly and rotate anti-clockwise to
remove.
Check and replace with a same rated LED (G10, 220-240V, 3W).
CLEANING
SAFETY PRECAUTION
Before cleaning your rangehood or performing any maintenance, please ensure that the rangehood is turned off
at the power point.
Do not use abrasive cleaners to clean the rangehood. The use of warm soapy water and a cloth is recommended.
Ensure that the rangehood is cleaned regularly, as a build-up of grease and fat may occur otherwise.
The filters on the rangehood must be cleaned regularly to maintain efficiency, and prevent grease build up. It is
recommended that this is undertaken every 4 – 6 weeks, depending on frequency of use.
The filters can be cleaned with warm soapy water or a cloth, or they may be washed in a dishwasher. If washed in
a dishwasher, discolouration may occur to the mesh and frame.
Cleaning of the range hood must be performed as described above, otherwise there is a possibility of a fire hazard
due to grease and fat build up.
Carbon filters must be used when recirculating the air back into the room. These must be replaced every 4 - 6
weeks, depending on the frequency of use.
TROUBLESHOOTING
Fault
Possible Cause
Solution
Light on, but
motor does not
work
Fan switch turned off
Select a fan switch position.
Fan switch failed
Contact Service.
Motor failed
Contact Service.
Light does not
work, motor
does not work
House fuses blown
Reset/Replace fuses.
Power cord loose or disconnected
Refit cord to power outlet.
Switch power outlet on.
Oil leakage
One way valve and the air ventilation
entrance are not tightly sealed
Take down the one way valve and seal
with sealant.
Leakage from the connection of U-shaped
section and cover
Take U-shaped section down and seal.
Lights not
working
Broken/Faulty globes
Replace globes as per this instruction.
Contacts bad
Re-set lights.
Insufficient
suction
The distance between the range hood and
the gas top is too far
Refit the range hood to the correct
distance.
Ventilation too little/too much
Adjust ventilation, open/close windows.
Loading ...