Loading ...
Loading ...
Loading ...
BEFOREYOU CALL
For problem laundry solutions (i.e. fabric damage, residue, tangling) and special laundry care procedures, see the
enclosed LaunderingTips booklet.
• Use Max Extract Spin Speed opdon.
Load isToo Wet at • Try usinga highefficiencydetergent to reduce sudsing.
End of Cycle , Load is too small. Very small loads (one or two items) may not be balanced and may not spin out
completely.
• Hake sure door isfirmly closed.
•Hake sure hoseconnections are tight.
LeaksWater • Make sure end of drain hose is correctly inserted and securedto drain facility.
•Avoid overloading.
•Use highefficiencydetergent to prevent over-sudsing.
•Check fuse or reset circuit breaker.
•Straighten drain hoses.Eliminatekinked hoses. If there isa drain restriction, call for service.
Won't Spin • Close the door and pushthe Start/Pause touchpad. For your safety,washer will not tumble or spin
or Drain unless the door isclosed.
•After pressingthe StarTJPausetouchpad, it will take 30 secondsbefore the clothes washer beginsto
spin. The door must lock before spin can be achieved.
•See"Tub is Completely Fullof Suds"below.
•Plugcord into live electrical oudet.
• Check fuse or reset circuit breaker.
•Close door and push the Start/Pause touchpad to start the clothes washer. For your safety,washer
Stops will not tumble or spin unlessdoor isclosed.
•This may be a pauseor soak period in the cycle. Wait briefly and it may start.
• Check screens on inlet hosesat the faucets for obstructions. Clean screens periodically.
• Run the clothes washer through another complete cycle usingcold water.
Tub is Completely • Reduce detergent amount for that specificload size,soil level and water hardness.
Full of Suds • Use highefficiency or low sudsingdetergent speciallyformulated for front load washers.
•Turn both faucets on fully.
• Make sure temperature selection iscorrect.
Fills with the • Hake sure hosesare connected to correct faucets. Flushwater lines.
Wrong • Check the water heater. It should be set to deliver a minimum 120°F (49°C) hot water at the tap.
Temperature Also check water heater capacity and recovery rate.
Water • Disconnect hosesand clean screens. Hose filter screens may be plugged.
• When warm rinse is selected, only the final rinse will be warm. The first two
rinses will be cold.
•As the washer is filling,the water temperature may change as the automatic temperature control
feature checks incoming water temperature. This is normal.
•The washer features an automatic temperature control to provide a warm wash of approximately
105" F and cold wash of approximately 65" E While the washer isfilling,you may notice only hot
and/or only cold water going through the dispenser when cold or warm wash temperatures are
selected. This isa normal function of the automatic temperature control feature asthe washer deter-
mines the temperature of the water.
2O CONTINUED
Loading ...
Loading ...
Loading ...