Loading ...
Loading ...
Loading ...
SAFETY WARNING: Never put your hand into area housing the fan while the fan is operating!
For optimal operation, clean range hood and all baffle/spacer/filter/grease tunnel/oil container regularly. Regular care will
help preserve the appearance of the range hood.
Cleaning Exterior surfaces:
• Clean periodically with hot soapy water and clean cotton cloth. DO NOT use corrosive or abrasive detergent (e.g.
Comet Power Scrub
®
, EZ-Off
®
oven cleaner), or steel wool/scoring pads, which will scratch and damage the stainless
steel surface. For heavier soil use liquid degrease such as “Formula 409
®
” or “Fantastic
®
” brand cleaner.
If hood looks splotchy (stainless steel hood), use a stainless steel cleaner to clean the surface of the hood. Avoid getting•
cleaning solution onto or into the control panel. Follow directions of the stainless steel cleaner. CAUTION: DO NOT
leave on too long as this may cause damage to hood finish. Use soft towel to wipe off the cleaning solution, gently
rub off any stubborn spots. Use dry soft towel to dry the hood.
After cleaning, you may use non abrasive stainless steel polish such as 3M•
®
or ZEP
®
, to polish and buff out the stainless
luster and grain. Always scrub lightly, with clean cotton cloth, and with the grain.
DO NOT allow deposits to accumulate or remain on the hood.•
DO NOT use ordinary steel wool or steel brushes. Small bits of steel may adhere to the surface and cause rusting.•
DO NOT allow salt solutions, disinfectants, bleaches, or cleaning compounds to remain in contact with stainless steel•
for extended periods. Many of these compounds contain chemicals, which may be harmful. Rinse with water after ex-
posure and wipe dry with a clean cloth.
Cleaning Stainless Steel Baffle Filter:
IMPORTANT: Drain oil from baffles, spacers, filters, oil tunnels, oil containers before oil and residue overflow!
Remove all baffles, spacers, filters, grease tunnel, and oil containers and discard oil and residue.•
Wash with warm soapy water. NOTE: Stainless steel baffles, spacers and oil tunnel are top rack dishwasher safe.•
Dry thoroughly before replacing and follow directions for installation in reverse.•
Filters should be cleaned after every 30 hours of use.•
Replacing Filters:
Replace filters if they wear out due to age and prolonged use.•
Replacing the light bulb:
SAFETY WARNING N
Maintenance
WARNING
Hazard of Burns!
Light bulb become extremely hot when turned on.
DO NOT touch bulb until switched off and cooled.
Touching hot bulbs could cause serious burns.
Page 23
1 Remove baffle filter as per installation.
2 Make sure the hood is disconnected or close the circuit
breaker.
Reach into the range hood and disconnect power clip.
3 Reach into interior of range hood until touching both lateral clips
located on the side of the puck light. Gently squeeze and push
down until puck pops out from its location.
4
To reinstall new puck light, follow instruction 3
in reverse order.