Loading ...
Loading ...
Loading ...
Dryer Symptom Possible Cause/Solution
Dryer is noisy • Check dryer for foreign objects (nails, coins, bobby pins, metal,
plastic toys, etc.). Remove items from dryer.
• Make sure dryer is level. Uneven leveling can cause vibration.
• Normal operating sounds include the heat source going on and off
and the humming of air moving through the dryer and exhaust sys-
tem.
Clothes are too wrinkled • Check heat setting. Overdrying can cause wrinkling.
• Check load size. Large loads may not tumble properly and may
cause wrinkling.
• On Auto-Sensing cycles, try using Steam Boost to release wrinkles.
Clothes have odor • Check room for odors before drying clothes. Any odor (fried foods,
paint, varnish, cleaners, burning wood, etc.) will transfer to clothing
as the dryer draws air from the room.
• Ventilate room before drying clothes.
Cycle advances too slowly • When in an Auto-Sensing cycle, the time it takes depends on the
type and size of the load being dried. When clothing has more
moisture, the cycle takes longer than when the clothes are more
dry.
Er, ro on digital display
• The dryer’s motor overload protector has cycled.
• The control can be cleared by pressing the Start/Pause button and
the dryer can be restarted by pressing the Start/Pause button
again.
• If this code is displayed again, remove the dryer from use and call
a service person.
Items still wrinkled after the steam cycle. • Do not overload the machine. Overloading the machine can cause
wrinkles to not be completely removed.
Items are damp or wet after steam cycle. • Do not overload the machine. Overloading during the steam cycle
can cause the load to have wet spots at the end of the cycle.
• Do not use overly damp items. This may result in the load not dry-
ing completely.
Small amount of water on door or in the drum. • When using the steam options, it is normal for condensation to oc-
cur.
Small amount of water on the floor in front of the dry-
er.
• Condensation may occur and drip from door when opened.
• Too small of a load may result in additional condensation on door.
Try adding more items to the load.
Small amount of water on the floor behind the dryer. • Check the hose connections and tighten them if needed.
• Check that the rubber washer is intact. If not, install the rubber
washer.
Warranty Repairs
If your appliance needs repair, you can locate an authorized
service provider directly from our Support page at www.speed-
queen.com.
Before scheduling service, please consult Limited Warranty for
full terms. As a reminder, the following items are not covered
by the limited warranty and, if a service technician is called,
you will be responsible for payment of the service call.
• Plugged or restricted venting
Troubleshooting
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
19 Part No. D518541ENR4
Loading ...