Loading ...
Loading ...
Loading ...
TO REPLACE BELT
1. Slide washers
and end caps onto
agitator assembly.
2. install new
belt over motor
drive, then
over brush
sprocket.
NOTE: Use
belt #20-5201.
In Canada,
#20-4097&
.ko,
Agitator
3. Place agitator
assembly back into
Power-Mate _ .
4. Reinstall
agitator
cover by lin-
ing up the
front tabs
and slots
and rotating _=_
downward €
until the
latches
snap into place°
Agita tot Co ver
Tabs
5. Line up
front of
cover and
base. Rest
cover on
front edge of
base as
shown.
Cover
6. NOTE: On dirt
sensor models
be sure that the
board is upright
and the wires are
tucked back as
shown.
7. Rotate cover
back. Press cover
firmly until side
and rear tabs snap
into place. Turn
Power-Mate ®
upside down and
replace two (2)
cover screws.
Base
J Top View
1. Remove Power-Mate ® cover as shown in
BELT CHANGING AND AGITATOR CLEAN-
ING section.
_'-_,_.__Pushlnt 1
And Turn _
2. Push in and turn
bulb counterclock-
wise, then pull out
to remove.
3. Push in and turn
bulb clockwise, to
replace. Bulb must
not be higher than
15 Watts(130 Volts).
4. Reinstall Power-Mate e cover as shown in
BELT CHANGING AND AGITATOR CLEAN-
ING section.
NOTE: Use bulb #20-5240. In Canada,
#59618!_
18
Loading ...
Loading ...
Loading ...