Loading ...
Loading ...
Loading ...
Setting Surface Controls (cont'd)
Operating the TRIPLE Surface Element
The cooktop is equipped with a TRIPLE radiant surface
element located at the right front cooktop position (Figure t).
indicator lights on the control panel at that position are used to
indicate what portions of the Triple radiant element will heat.
The INNER light indicates that only the inner element will heat.
The +MIDDLE light indicates that both inner and middle
elements will heat together. The ALL light indicates that all 3
portions of the element will heat. You may switch between all
of these different settings at any time during cooking.
To Operate theTriple Surface Element:
1.
Place correctly sized cookware on the radiant surface element.
2.
3.
4.
Touch and hold the pad for the Triple element position until Figure 3
a beep is heard. The display will show " - - "
Note: If no further pads are touched within 10 seconds the request to power
the element ON will clear.
Select the INNER (See Figure 2), +MIDDLE (See Figure 3) orALL 3
elements (See Figure 4) to heat by pressing the _M_._ pad once, twice or
three times (Figures 4 & 5 show indicator lights with ALL 3 elements
selected).
Touch HI _-_ pad once to turn ON the power level to HI. Touch Lo
(_) pad for Lo The Not Surface indicator will
once
(See Figure 5). light
turn ON when the element becomes hot.
Each touch of the HI _ or Lo _-'_) pad will decrease or increase the
power level from 9.0 through 3.0 by .5 increments. Simmer power levels
between 3.0 and 1.2 will decrease or increase by .2 increments. Lo is the
lowest power level available.
Note: The power level may be adjusted at any time while the element is ON.
6.
When cooking has been completed touch the ! pad once to turn the
element OFF.
Each surface element provides a constant amount of heat at each setting.
A glowing red surface heating area extending beyond the bottom edge of the
cookware indicates the cookware is too small for the surface heating area.
Note: The Hot Surface indicator light will remain ON if the cooktop is still
hot and will remain ON until the heating surface area has cooled sufficiently.
Figure 4
HI @o ALL
@ o +MIDDLE
L0 INNER
Figure 5
Note: If no element size is chosen when the Triple element is turned ON, the control will default to the inner coil only.
See page 9 for recommended surface cooking settings.
Radiant surface elements may appear to have cooled after they have been turned off. The glass surface
may still be hot and burns may occur if the glass surface is touched before it has cooled sufficiently.
Do not place aluminum foil or plastic items such as salt and pepper shakers, spoon holders or
plastic wrappings on top of the range when it is in use. These items could melt or ignite. Potholders, towels or
wooden spoons could catch fire if placed too close to the surface elements.
11
Loading ...
Loading ...
Loading ...