GE - General Electric SSS25KFMAWW GE refrigerator - m series

User Manual - Page 24

For SSS25KFMAWW.

PDF File Manual, 38 pages, Download pdf file

Loading ...
Loading ...
Loading ...
Removingandreplacing the doors.
When installing or moving the refrigerator, the doors may need to be removed in order to fit the refrigerator through
a doorway.
Removing the Doors
Make sure the doors are closed and the refrigerator is
unplugged.
0 Disconnect water line and wiring harness.
Near the lower hinge on the fl'eezer side, push in on the
collm_ at each end of the coupling, and pull the water
line robing fl'om the coupling. _Mso, disconnect wiring
harness. Pull the water line and the harness through the
lower rail.
0 Remove the hinge covers and the hinges.
In order to access the hinges, the hinge co\'e_ need to be
relnoved. Remove the cover b v grasping it on the sides,
near the back of the coveI: Push back on the cover and
lift up at the back, then the fl'ont.
NOTE: DONOTusea screwdriverto removethecover BECAREFUL
not tobreak the rear retainingtab on thehingecover Removethe
hlbgesuslbga TorxT-20.
0 Remove the doors.
(:arefhllv rotate the door to 90? Guiding the disconnected
water line and wiring harness, lift the door straight up.
NOTE: Not rifting the doorstraight up may damagethebottom hinge.
Piecedoorsona protectedsurface.
/VOTE:Becareful not topinch the water tubingand the wire harness
at thebottom of the door
/VOTE:Donot a//ow the connectorto contact the floor Hardcontact
can damagetheconnector See "Replacingthe Doors."
Replacing the Doors
0 Place doors on bottomhinges.
( o
X'_ith the door at .)0, lower the door straight down onto
the bottom hinge. Careflflly close the door.
NOTE: Not lowenbg the doorstre/ght down onto thebottom hinge
may damagethehinge.
NOTE'.Donot allow the connectorto contact the floor Hardcontact
can damagetheconnector
0 Replace tophinges and hinge covers.
Reinstall the top hinges using a Torx T-20. Replace the
hinge cove_. If the doo_ are not level, ac!iust the bottom
right hinge with a 7/16" open ended wrench.
0 Reconnect water line and wiring harness.
Insert water robing back into coupling, making sure the
tubing is pushed flu" enough into the coupling so that wm
no longer see the mark on the tubing. Reconnect the
widng harness.
0 Turnonthe water supplyand plug the refrigerator back in.
_ HingeCover
Door
HingePin
Connector
24
Loading ...
Loading ...
Loading ...