Loading ...
Loading ...
Loading ...
- 12 -
10. CONNECTION
10.1. PREPARATION
1) Switch the ignition on.
2) The vehicle battery voltage should be 9-14V.
3) Throttle should be in a closed position.
10.2 LOCATE VEHICLE'S DLC
The DLC (Data Link Connector) provides standard 16 pins
and is generally located on driver 's side, about 12 inch away
from the centre of dashboard.
See Figure DLC Location. If DLC is not equipped under
dashboard, a label indicating its position will be given. In case no DLC is found, please refer to
Automobile Repair Manual.
10.3 CONNECTION
Select the desired diagnostic connector according to the vehicle DLC type and then follow the
steps below to proceed:
1. For vehicles equipped with an OBD 11 management system
Plug the VCI connector into the vehicle's DLC directly or use the OBD II extension cable to
connect the VCI connector and the DLC.
2. For vehicles NOT equipped with an OBD 11 management system
Do the following:
1). Select the corresponding non-16pin connector.
2). Plug the non-16pin end of the connector into the DLC socket, then connect the other end
to the OBD I adaptor, and then tighten the captive screws.
3). Connect the other end of the adaptor to the VCI connector.
4). To supply power to OBD I adaptor from:
A. Battery Clamps Cable (optional): Connect one end of the battery clamps cable to
vehicle's battery, and the other end to the power jack of OBD I adaptor,
OR
B. Cigarette Lighter Cable (optional): Connect one end of the cigarette lighter cable to
vehicle's cigarette lighter receptacle, and the other end to the power jack of OBD I
adaptor.
Help
DLC Location
Near centre of dashboard
Loading ...
Loading ...
Loading ...