Loading ...
Loading ...
Loading ...
5
Vent Cover Installation
(for both upper vent and wall vent installation)
1. Remove screws attaching vent cover B, C and D to top of
microwave exterior. Slide out vent covers B, C and D.
Keep the vent cover C for step 2 use.
2. Place the vent cover C (removed from step 1) to area A, and
rotate 180 degrees.
3. Attach the vent covers located in the upper
polyfoam (see item J in "Parts Supplied" section).
4. Attach the vent covers to vents B & C using the
screws removed in step 1.
A
B
C
D
A. Screws
B. Vent Cover
C. Vent Cover
D. Vent Cover
E. Top front of the
microwave
B
C
A
A
A. Screw
B. Vent cover (located
in upper polyfoam)
C. Vent cover (located
in upper polyfoam)
E. Top front of the
microwave
Locate Wall Stud(s)
NOTE: If no wall studs exist within the cabinet opening, do not
install the microwave oven.
See illustrations in “Possible Wall Stud Configurations.”
1. Using a stud finder, locate the edges of the wall stud(s)
within the opening.
2. Mark the center of each stud and draw a plumb line down
each stud center. See illustrations in “Possible Wall Stud
Configurations.”
Charcoal Filter
Grease Filter
E
E
E
NOTE:
Keep the vent cover B and vent cover D for
recirculation in future.
B
C
3. Secure damper assembly with 2 Sheet metal screws
5
/
32
" x
5
/
16
" (0.4 cm x 0.8 cm).
Note: To ensure good performance of airflow, for Wall and Roof
venting, remove the charcoal filter from the bottom plate before
operating the microwave oven.
Loading ...
Loading ...
Loading ...