Loading ...
Loading ...
Loading ...
QUICK START GUIDE
u-line.com
QUICK START GUIDE
15
u-line.com
CRESCENT ICE MAKERS AND ADA15IM
1.
Fully open door/drawer.
2.
Starting at corner, pull
gasket away from door/
drawer.
3.
Continue to pull gasket
free from gasket channel.
4.
Upon removal, lay gasket
down on a flat surface.
5.
Partially loosen the 3 screws, securing the top hinge to
the cabinet.
6.
Align the panel with the outside edge (opposite the
hinge) and high enough to align with the highest point
in the door/drawer.
7.
Insert panel underneath top hinge and apply upward
pressure while bringing the lower portion of the panel
flush to the door inside the lower hinge. The panel will
fit snuggly
8.
Align door with cabinet. Tighten the top 3 screws,
securing the top hinge to the cabinet.
Due to differences in floor construction or
surrounding cabinetry, the panel may not sit
flush with the top of the door/drawer.
9. Secure integrated
panel to door/drawer
using clamps. A
robust tape may also
be used. U-Line
recommends the use
of bar clamps to
secure the panel to
the door/drawer. If
using tape, be
certain the tape will
not damage panel
finish upon removal.
10.Using a 7/64" (3 mm)
drill bit, drill 6 pilot
holes into the wood
panel 1/2" (12 mm)
deep using the holes in the door/drawer frame as a
guide.
It is important to ensure that all drilled holes are
drilled to the correct depth in order to avoid
splits in the wood when hardwood is installed.
11.Locate 6 of the #6x 1-1/4" (32 mm) screws provided
with your unit.
12.Using a Phillips screwdriver, place one screw into each
of the 6 pilot holes and screw down. Do not over
tighten screws.
Align Panel
Against
Door/Drawe
Edge First
Align Top Of Panel With Highest Point Of Door/Drawer
Door
Panel
Wood
Panel
Door/Drawer
Bar
Clamp
Bar
Clamp
15
Loading ...
Loading ...
Loading ...