Loading ...
Loading ...
Loading ...
S
TO REPLACE FUSE
CE AN ADJUSTMENTS
Replace with 30 amp automotive-type plug-in fuse, The
fuse holder is located in the engine compartment, directly
in front of the dash.
TO REPLACE HEADLIGHT BULB
o Raise hood.
o Pull bulb holder out of the hole in the backside of the
grill.
, Replace bulb in holder and push bulb holder securely
back into the hole in the backside of the grill.
* Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your tractor to run
poorly, stop running or prevent it from starting.
- Check wiring. See the electrical wiring diagram in the
Repair Parts section of this manual.
TO REMOVE HOOD AND GRILL (See Fig. 30)
,, Raise hood. _
• Unsnap headlight wire connector.
• Stand in front of tractor. Grasp hood at sides, tilt
forward and Liftoff of tractor.
• To reinstall, slide hood pivot brackets into slots in
frame.
• Reconnect headlight wire connector and close hood.
HOOD
HEADLIGHT
WIRE
CONNECTOR
ENGINE
TO ADJUST THROTTLE CONTROL CABLE
(See Fig. 31)
The throttle control has 1seenpreset at the factory and
adjustment should not be necessary. Check adjustment as
described below before loosening cable. If adjustment is
necessary, proceed as follows:
= With engine not running, move throttle control lever
from slow (,,am,)to choke (N) position. Slowly move
lever from choke (1\1)to fast (,1_) position.
Check that holes"A" in governor control lever and hole
in governor plate line-up. If holes "A" are not aligned,
loosen clamp screw and move throttle cable until holes
are aligned. Tighten clamp screw securely.
GOVERNOR
CONTROLLEVER
GOVERNOR
CONTROLPLATE
O
o
HOLES"A"
CLAMP
SCREW
THROTTLE
CABLE
FIG. 31
FiG. 30
24
Loading ...
Loading ...
Loading ...