Loading ...
Loading ...
Loading ...
Door Removal and Reversal Instructions (continued)
TRIM REMOVAL (FULL-LENGTH TRIM MODELS ONLY)
h7some moaels, the refrigerator aoor nasa fu ength trim piece wnlcn
continues from the bottom of the handle to the bottom of the door. The top
of the trim attaches to the handle bracket Fgure 1 or fits arouna me base
of the handle F gure 2t An adhesive "trim lock" is oositioned about halfway
down. The bottom of the trim is held in p_aceoy eEner an aoneswe _nm_OCK.
or atrim lOCKw*m two prongs _nsenea nto a hole on the face of the door.
TO REMOVE TRIM:
1. Remove trim by gently pulling _nm_OCKareas out ana away from door.
2. When trim is free from door. sHae me _nm s[ra_ght down and away
from base of handle.
NOTE: For models with snort handle trim, remove by sliding trim
stralgnt down and off of handle bracket.
TO REMOVE REFRIGERATOR HANDLE:
(Handles may oe easier _o reverse wn_e coors are off./
Figure 1Style Handles
1. Remove two screws a[_acnlng qanale to _ODof refr gera[or aoor
2. Remove screw attaching bottom of handle to aoor.
3. Remove two no_eD_ugsana _'_ge p_np_ug on _op of door and install
on opposite side. Use Phillips head screwdriver to remove plastic
screw plug from front of door and install on opposite side
Figure 2 Style Handles
1. Remove two screws attaching handle to top of refrigerator door.
2. Swing top of handle away from door and slide handle down and off of
dovetail button.
3. Remove screw and dovetail button and install on other side, moving
hole plugs from corresponding holes to opposite side.
TO ATTACH REFRIGERATOR HANDLE:
Figure 1Style Handles
1. Secure bottom of handle with screws.
2. Secure top of handle with screws.
Figure 2 Style Handles
1. Start with handle offset away from door. Place bottom of handle over
dovetail button, swing handle into an upright position and pull upward,
locking it into place.
2. Secure top of handle with screws.
TO ATTACH TRIM:
1. Slide both trim locks out of trim.
2. Insert new adhesive trim locks contained in your literature pack.
NOTE: Trim lock must be removed and installed by sliding over the
two donut shaped areas.
3. Install trim to handle by sliding under base of handle. Carefully align
trim and press down at trim lock locations.
4. Use rubbing alcohol to remove any adhesive residue from old trim
lock locations.
Adhesive
Trim
Full
Length
Figure 1
LockHandle
over
Dovetail
rl
Adhesive
Lock
Trim
Lock
Figure 2
8
Loading ...
Loading ...
Loading ...