Loading ...
Loading ...
Loading ...
9
6.3 HANDLE ATTACHMENT - FIG. 3
6.4 BLEEDING AIR FROM THE SYSTEM
Prior to operating the jack, the hydraulic circuit must be purged to expel any accumulated
air from the system.
1. Push the lever to the down position. Hold the lever in this position for a few seconds.
2. Without any load, continue to operate the jack. Ensuring the jack reaches the highest
point and returned to the lowest.
3. Repeat last step until the movement of the piston is smooth & consistent before using
with any load applied.
6.3 OPERATION
1. IMPORTANT: Prior to lifting the load, ensure that all of the afore mentioned safety
instructions are followed.
2. The wheels of the jacks should always rotate freely.
3. For lifting, use the handle to position jack saddle pad into position below approved
vehicle lifting point (check correct position with vehicle manufacturer before lifting) once
jack contacts lift point, move the control lever to the ‘up’ position. Secure the lifted load
as an essential safety measure with appropriate axle stands.
4. Before lowering, lift the vehicle to remove the axle stands, ensuring that there are no
persons or obstacles under the vehicle to be lowered. Carefully move the control lever
to the ‘down’ position to gently lower the load.
5. Once finished, the air supply can be disconnected and the jack can be stored
accordingly.
6. OPERATING INSTRUCTIONS
FIG.3
$
%
$
%
Loading ...
Loading ...
Loading ...