Loading ...
Loading ...
Loading ...
Installation
Preparation
Ensure that there are no electric wires, gas or water pipes in the area where holes
are to be made.
1. Ensure that that there is an electrical plug socket within adequate distance of
the hood after it has been installed.
2. Mark a vertical centre line on the wall from the ceiling to the lower edge of the
extractor hood.
3. Mark the positions for the screws and the contour of the attachment area.
4. Drill 3 x 10mm Ø holes to a depth of 50mm for the hood fixing bracket and press
the wall plugs flush with the wall.
5. Drill 2 x 10mm Ø holes to a depth of 50mm for the flue fixing bracket and press
the wall plugs flush with the wall (at the appropriate height and will depend on the
height of the ceiling).
6. Drill 2 x 10mm Ø holes to a depth of 50mm for the hood fixing screw and press
the wall plugs flush with the wall (at the appropriate height and will depend on the
height of the ceiling).
7. Screw on the hood and flue fixing brackets with the large screws.
All measurements in the below diagram are in millimetres (mm)
10
Flue duct fixing bracket
Hood fixing bracket
Hood fixing screws
Loading ...
Loading ...
Loading ...