Loading ...
Loading ...
Loading ...
10
LP Gas Connection
The LP hose regulator is not included with the grill and
needs to be purchased separately.
Appliance pressure 10” W.C.
Inlet pressure 11” – 14” W.C.
Purchase a standard 20 LB. LP tank with QCC – 1 fitting.
Assemble pipe/hose assembly as shown.
After completion of assembly, turn the tank valve on and turn the
control valves on the grill to the ‘HI/IGN’ position for 10 – 15
seconds to purge the line of air.
Inspect the hose before each use of the appliance. If it is evident
there is excessive abrasion or wear, or the hose is cut, it must be
replaced prior to the appliance being put into operation. The
replacement hose assembly shall be that specified by the
manufacturer.
To connect, insert the regulator inlet into the tank valve and turn
the black coupler clockwise until the coupler tightens up. DO NOT
OVER TIGHTEN THE COUPLER.
To disconnect, turn the tank valve off. Hold the coupler sleeve and
turn counter clockwise. The inlet line will be disengaged.
If the appliance is not in use, the gas must be turned off at the
supply cylinder. Cylinder must be stored outdoors out of reach of
children and must not be stored in a building, garage or any other
enclosed area.
A dented, rusty or damaged propane cylinder must be replaced
immediately.
Check for leaks with a soapy water solution every time the
cylinder is replaced or reconnected. All leaks must be corrected
immediately. Never use an open flame to check for leaks.
LP Tank Requirements
The L.P. gas cylinder must be constructed and marked in accordance with the specifications for L.P. gas
cylinders of the U.S. Department of Transportation (DOT) and designed for use with a QCC-1 quick
disconnect system only.
The cylinder must be provided with a shut-off valve terminating in an L.P. gas supply cylinder valve outlet
specified, as applicable, for connection No. QCC-1.
The cylinder must be provided with a listed overfilling prevention device. The pressure regulator and hose
assembly supplied with the outdoor cooking gas appliance must be used. Replacement of pressure
regulators and hose assemblies can be purchased from authorized dealers.
The cylinder supply system must be arranged for vapor withdrawal. Make sure the LP cylinder has a collar to
protect the cylinder valve. Do not store a spare LP gas cylinder under on near this appliance.
(a) Never fill the cylinder beyond 80 percent full.
(b) If the information in (a) and (b) are not strictly followed, a death-causing fire or serious injury may
occur
Loading ...
Loading ...
Loading ...