Loading ...
Loading ...
Loading ...
CONTROL PURPOSE COMMENTS
To reset any cycle or
Cancel options during
DRAIN selection.
To cancel a wash
cycle after it's
started.
Press and hold CANCEL/DRAIN to reset any control selections made.
See "Canceling A Cycle" and "Changing A Cycle After Dishwasher Is Started" sections.
HFTemD To turn the audible Press and hold the Hi-Temp sCrub button for3 Seconds to turn the audibie tones on croft.
' '_;sh 5 tones 0n or off. Only audible tones for confirming button presses can be turned on/off, Important audible
tones, such as indicating a cycle has been interrupted, cannot be deactivated,
SoundOn/Off
Hold 3 Sec
CONTROL PURPOSE COMMENTS
The CYcle Status Indicator Clean indicator glows When a CYCleis finished.
;..... !f yOu select the Sanl Rinse option; when the Sanj Rinse cycle !s finished,
progress of [ne a snwasner
or, , . :. =. ; the Sanitized indicator g!ows, lf your dishwasher did not proper!y sanitize
cycle Locatea on tne Tront
_ID,._I i °--'-.- . ° _ ', your dishes, the light flashes at the end of the cycle. This can happen if the
..... '°_'_'°,_ '0"'°° OTthe a snwasner TOrTront • •
, , , , • . _ _ . _ cyc e s interrupted or the water could not be heated to the required
control moae!s ana iocatea tem'-erature
Or on the top of the door for _ P
2,1 _.i _,, c,_,.._,,;_,_ ........ hidden Control models, ........ The C ean and San t zed ghts go Off when you open and c ose the door Or
p_ess and hold CANCELI
A
The Front Indicator Light or
Single Exterior Light (A)
shows progress of your
dishwasher cycle by color
(for hidden control models
only).
The light will be blue if the dishwasher is washing or rinsing. The light will
be red when the dishwasher is drying. The light will be white to indicate
that the cycle is complete. If the Front Indicator Light is blinking, see
"Troubleshooting" section.
The Cycle Status Display is The indicators Wi!! inform you if you are able to add a dish to the cyCle after
used to follow the progress it has started. It will a!so inform you if the dishwasher is washing, rinsing,
of the dishwasher cycle, and drying, complete, and!or sanitized, They will show whether the control is
to show 0ther information: locked and/or the delay 0Ption is se!ected. A sedes of bars wi!! count down
(Availab!e on some mode!s the duration of the cyc!e remaining f[om left t0 right, Each bar equals
instead of Cycle Status approximately 24 minutes of cycle length. The bars will also count down
Indicator Lights)the delay feal_ure fro m left to right, and the delaY indicator Wi!! be activated.
After every 30 cycles, the dishwasher Will display "affresh;" pioViding a
temporary reminder for,,you to perform a monthly maintenance PrOCedure.
See Dishwasher Care section:
Canceling a Cycle
1. Open the door slightly to stop the cycle. Wait for the spraying
action to stop before completely opening the door.
2. Press and hold Cancel/Drain button once. The Cancel/Drain
light will light up.
3. Close the door and the dishwasher starts a drain cycle (if water
remains in bottom of dishwasher). Let the dishwasher drain
completely. The Cancel/Drain light turns off after 2 minutes.
Changing a Cycle After Dishwasher Is Started
1. You can interrupt a cycle and restart your dishwasher from the
beginning using the following procedure.
2. Open the door slightly to stop the cycle. Wait for the spraying
action to stop, then open the door completely.
3. Check that detergent dispenser cover is still closed. If cover is
open, you will need to refill the detergent dispenser before
restarting your new cycle.
4. Press and hold CANCEL/DRAIN twice to reset the control.
5. Select new cycles and options.
6. Press START/RESUME.
Adding a Dish After Dishwasher Is Started
1. Check if Add a Dish indicator is lit. (Available on some models.
Otherwise, proceed to Step 2.)
2. Open the door slightly to stop the cycle. Wait for the spraying
action to stop, and then open the door completely.
3. Check whether the detergent dispenser cover is still closed. If
it is open, the wash cycle has already started and adding a
dish is not recommended.
4. If detergent has not yet been used (detergent dispenser cover
is closed), you may add a dish.
5. Press START/RESUME.
11
Loading ...
Loading ...
Loading ...