Loading ...
Loading ...
Loading ...
4
www.factorybuysdirect.com
200274-01A
INSTALLING LOGS
WARNING: Failure to position the parts in accordance with these
diagrams or failure to use only parts specically approved with this
heater may result in property damage or personal injury.
CAUTION: After installation and periodically thereafter, check to
ensure that no yellow ame comes in contact with any log. With the
heater set to High, check to see if yellow ames contact any log. If
so, reposition logs according to the log installation instructions in
this manual. Yellow ames contacting logs will create soot.
It is very important to install the logs exactly as instructed. Do not modify logs. Use only logs
supplied with heater.
Each log is marked with a number. This number will help you to identify the logs when installing.
After installing logs, add decorative cinders on the ember ports, do not place any decorative
cinders on the main burner ports or on the logs (see illustration below).
Rear Log
Bracket
Main Burner
Ports
Ember Ports
Middle Log
Bracket
Grate Assembly
Ember Material
Burner
PLACING EMBER MATERIAL
Separate the ember material into light pieces
smaller than the size of a dime. Place the
pieces around the round gas ports starting in
the front of the burner and working your way
toward the back of the burner. Do not place
ember material on the burner ports or the
carry over ports leading to the left and right
rear burner slots.
WARNING: Use only ember
material provided with log set.
Do not add additional ember
material.
Place ember material on front
burner port only. DO NOT PLACE
EMBER MATERIAL ON PORTING
BEYOND THE GRATE, OVER THE
MIDDLE OR BACK BURNERS.
Loading ...
Loading ...
Loading ...