Loading ...
Loading ...
Loading ...
Style 2: Digital Controls (on some models)
For your convenience, your controls are preset at the factory.
When installing your refrigerator, make sure that the controls are
still preset to the "mid-settings" as shown. The digital control
panel is located at the top of the refrigerator compartment and
enables you to view the temperature control set points.
NOTE: The factory recommended set points are 0°F (-18°C)
for the freezer and 37°F (3°(3) for the refrigerator.
To turn refrigerator on and view set points:
• Press and hold ON/OFF for 2 seconds.
LOW FREEZER REFRI6ERATOR COLD
COLDER COLDER
To view the Celsius temperatures:
• Press the °C SELECT touch pad. The indicator will light up.
To redisplay degrees Fahrenheit, press °C SELECT again.
NOTE: If the freezer temperature is below zero, the indicator light
next to the freezer display will light up.
Adjusting Digital Controls
NOTE: Wait at least 24 hours between adjustments. Recheck
the temperatures before other adjustments are made.
To adjust set point temperatures:
• Press the refrigerator or freezer up or down arrow until the
desired temperature is reached.
REFRIGERATOR COLD
COLDER
• The set point range for the freezer is -5°F to 5°F (-15°C to
-21 °C) and 33°F to 41 °F (1°C to 5°C) for the refrigerator.
CONDITION/REASON: TEMPERATURE
ADJUSTMENT:
REFRIGERATOR too cold REFRIGERATOR Control 1°
higher
REFRIGERATOR too warm REFRIGERATOR Control 1°
- High use or room very warm lower
FREEZER too cold FREEZER Control 1° higher
FREEZER too warm/too little FREEZER Control 1° lower
ice - High use or heavy ice use
Additional Digital Control Panel Features
Additional features are located on the control panel at the top of
the refrigerator compartment.
WATER FILTER Status & Reset
NOTE: Do not use with water that is microbiologically unsafe
or of unknown quality without adequate disinfection before
or after the system.
The water filter display will help you know when it is time to
change your filter. To change the filter, see the "Changing a Base
Grille Filter" section.
INDICATOR: STATUS:
99 percent New filter installed
10 percent Order replacement filter
0 percent or flow decreases Replace filter
• After replacing the water filter, press RESET and hold for 2
seconds to change the water filter display to 99 percent.
WATERFILLER
PERCEI_REMAININ6
GrocerySavor TM
The GrocerySavor feature assists with periods of high
refrigerator use, full grocery loads, or temporarily warm room
temperatures.
• Press GrocerySaver to set the temperatures to
-10°F (-23°C) for the freezer and 34°F (1°C) for the
refrigerator. The GrocerySavor indicator light will remain on
for 24 hours unless manually turned off.
NOTE: The temperature display will not change. After 24
hours, the refrigerator returns to the previous temperature set
points.
Accelerated Ice Production
This feature assists with temporary periods of heavy ice usage by
increasing ice production over a 24-hour period.
• Press the accelerated ice production touch pad to set the
freezer temperature to -10°F (-23°C). The refrigerator
temperature will not change. The accelerated ice setting will
remain on for 24 hours unless manually turned off.
NOTES:
• The temperature display will not change. After 24 hours, the
refrigerator returns to the previous temperature set points.
• If increased ice production is desired at all times, set the
Freezer Control to a colder setting. Adjusting the freezer to a
colder temperature may make some foods, such as ice
cream, harder.
11
Loading ...
Loading ...
Loading ...