Loading ...
Loading ...
Loading ...
EX07200-116
7
Failure to use proper voltage may result in personal injury and/or property damage. If the supplied electrical
connection is either damaged or not long enough, do NOT use an extension cord. Have a licensed electrician
replace the power cord.
INSTRUCTIONS FOR USE
CONGRATULATIONS: You are now ready to use your water heater. Run the hot water at a nearby sink and
evaluate the hot water temperature. Make any temperature adjustment using the section below.
SETTING THE THERMOSTAT
The mini tank water heater is equipped with an adjustable thermostat that once set will automatically control
water temperature. The red indicator lamp remains illuminated while the water is being heated. If the water
in the tank is at the desired temperature the lamp will NOT be illuminated.
The temperature adjusting knob will increase the temperature by turning the knob clockwise and decrease
the water temperature by turning the knob counter clockwise.
When not being used for a lengthy period of time, you can conserve energy by reducing the water
temperature setting.
FREEZE PROTECTION
When the water heater is not being used for an extended period of time and there is a risk of freezing,
disconnect power and drain the water heater.
MAINTENANCE INSTRUCTIONS
Always disconnect power when the supply water line is turned off or when servicing or draining the water
heater. Before calling for service, first confirm that the water heater is properly filled and that 110VAC power
has not been interrupted.
WARNING:
Before servicing or cleaning the water heater, turn off the POWER switch and disconnect power.
NOTE: Before performing maintenance, turn off the POWER switch, disconnect power, and drain all
water from the mini tank.
DRAINING AND REMOVING THE WATER HEATER
1. Disconnect power from the water heater.
2. Open a hot water faucet to let hot water run out. Allow water to flow until water is no longer hot.
3. Turn off the cold water supply to the water heater.
4. Close the hot water faucet.
5. Disconnect the water heater from both the hot and cold water connections.
6. If possible siphon out remaining water from the tank
7. Carefully detach the water heater from the wall.
8. Tilt the water heater to drain remaining water out of the heater.
CHANGING THE THERMOSTAT
1. Turn off the POWER switch and disconnect the water heater from the power supply.
2. Drain the water heater and remove from the wall (see above).
Loading ...
Loading ...
Loading ...