Craftsman 315177500 handheld vacuum

User Manual - Page 8

For 315177500.

PDF File Manual, 16 pages, Download pdf file

Loading ...
Loading ...
Loading ...
_k WARNING: Always wear safety goggles or safety
glasses with side shields when operating tools.
Failure to do so could result in objects being thrown
into your eyes, resulting in possible serious iniury.
RA'I-I'E RY PACK
The battery pack for your hand vac has been shipped in a
low charge condition to prevent possible problems.
Therefore, you should charge it overnight prior to use.
Note: Batteries will not reach full charge the first time they
are charged. Allow severa] cycJes (vacuuming followed by
recharging) for them to become fully charged,
CHARGING BATTERY PACK
See F:,gure 2.
Charge battery pack only with the charging assembly
provided.
Make sure power supply is normal household
voltage, 120 volts, 60 Hz, AC only.
Connect charger to power suppty.
Place battery pack in charging stand. Align raised rib
on battery pack with groove in charging stand.
See FTgure 2.
Press down on battery pack to be sure contacts on
battery pack engage properly with contacts in charging
stand.
The charge indicator light (LED), located on the
charging stand, will ligh_ up red and glow when the
charger is property connected to power supply. This
light indicates the charger is operating properly. It will
remain on until batiery pack is removed from charging
stand or charger is disconnected #om power suppty.
Note: If charger does not charge battery pack, return
battery pack and charging assembly to your nearest
Sears Repair Center for electrical check.
II1 After normal usage, 3 hours or less of charging time is
required to fully recharge battery pack. Note: ff battery
pack is completely discharged, 6 hours or longer of
charging time is required to fuU¥ recharge battery
pack.
The battery pack will become slightly warm to the
touch while charging. This is normal and does not
indicate a problem.
II1 Do not place charger in an area of extreme heat or
cold. It will work best at normal room temperature.
[] When batteries become fully charged, unplug charger
from power supply end remove the battery pack.
IMPORTANT INFORMATION FOR RECHARGING
HOT BA'I-|'ERIES
When using your hand vac continuously, the batteries in
your battery pack will become hot+You should let a hot
battery pack cool down for approximately 50 minutes
before attempting to recharge.
Note: This situation only occurs when continuous use of
your hand vac causes the batteries to become hot, It does
not occur under normal circumstances. Refer to "CHARG-
ING BATTERY PACK" for normal recharging of batteries.
If the charging assembly does not charge your battery
pack under normal circumstances, return both the battery
pack and charging assembly to your nearest Sears Repair
Center for electrical check.
BA'FI"ERYPACKSHOWN
INCHARGINGSTAND
CHARGER
REDLIGHT
(LED)
CHARGINGSTAND
Loading ...
Loading ...
Loading ...