Loading ...
Loading ...
Loading ...
- 10 -
ASSEMBLY
- FITTING THE ROUTER BIT GUARD (Fig.8):
- The router bit guard must be used when not
using the upper and lower blade guides, attach the bit
guard by lining up the fixing holes on the fence and
guard and inserting pin %. Fig.8
- FIXING THE REAR FENCE TO THE WORK TABLE
(Figs.9 - 13):
- Place the fully assembled rear moulded fence onto the
work table Fig.9.
- Remove the front panel by removing four cross slot
screws using a screwdriver (not supplied). Fig.10.
Note: Ensure spindle moulder is isolated from the mains
supply.
- Once the front panel has been removed, insert bolt 8
into the left locating hole from inside the spindle
moulder. Fig.11.
FIG.10
FIG.11
8
FIG.8
%
FIG.9
Loading ...
Loading ...
Loading ...