Loading ...
Loading ...
Loading ...
SERVICE AND ADJUSTMENT
HOW TO REPLACE THE FUSE
Ifthe fuse is blown, the engine will notstart. The location ofthe fuse
is next to the battery. Remove the fuse and replace with a 15 amp.
automotive fuse (Figure 39).
15 amp
_ Automotive Fuse
Figure 39
HOW TO SET THE cu'rrlNG HEIGHT
The cuttingheight is set at the factory from 1_/2to 4 inches. To lower
or raise the cutting height, make an adjustment to the lifter rod as
follows.
1. Move the lift lever to the lowest position.
2. Disconnect the lifter rod from the lifter arm (Figure 40).
3. Turn the lifter rod clockwise to lower or counterclockwise to
raise the cutting height.
4. Attach the lifter rod to the lifter arm.
5. Move the lift lever to the highest position. Make sure the pulleys
or belt do not touch the bottom of the frame.
Hair Pin
Lifter Rod
Figure 40
HOW TO CLEAN THE MOWER HOUSING
_lb WARNING: Before you clean the mower housing,
stop the engine and disconnect the wire to the spark
plug.
Grass and other debris on top of the mower housing can keep the
belt from working correctly. For safety and correct operation,
frequently clean the top of the mower housing. Remove grass and
debris from around the pulleys and other moving parts.
1. Move the lever for the attachment clutch to the ENGAGE posi-
tion.
F-99635
31
2. Clean the top of the mower housing.
3. Move the lever for the attachment clutch to the DISENGAGE
position.
4. Again clean the top of the mower housing.
5. After you cut the grass, clean the bottom of the mower housing.
FRONT WHEEL ALIGNMENT
The alignment of the front wheels cannot be adjusted. If the steering
is damaged and the alignment has changed, see your nearest
authorized service center.
Loading ...
Loading ...
Loading ...