Loading ...
Loading ...
Loading ...
17
The light does
not work.
• Appliance is not connected to a power
supply.
• Tripped circuit breaker or blown fuse.
• The light was switched off on the
control panel.
• Connect the appliance.
• Switch on the circuit breaker or
replace the fuse.
• Switch on the light.
Vibrations
• The appliance is not properly leveled.
• Level the appliance with the
adjustable feet.
The appliance
seems to
make too
much noise.
A rattling noise may result from the flow of the refrigerant, which is normal. As each
cycle ends, you may hear gurgling sounds caused by the flow of refrigerant in your
appliance.
If temperature fluctuations occur, the contraction and expansion of the inner walls
may cause popping and crackling noises.
• The appliance is not properly leveled.
• Level the appliance with the
adjustable feet.
The door will
not close
properly.
• The appliance is not properly leveled.
• The gasket is dirty.
• The shelves are out of position.
• Level the appliance with the
adjustable feet.
• Clean the door gasket.
• Check the shelves and refit correctly.
Display “E0”,
“E1”. “E2”,
“E3”, “E4”,
“E5” or “E7”.
• “E0” indicates a communication error
for 3-zone models.
• “E1” or “E2” indicates that the air
temperature sensor has failed.
• “E3” or “E4” indicates that the defrost
sensor in the evaporator has failed.
• “E5” indicates defrost heater failure.
• “E7” indicates door switch failure.
• Call for service.
The alarm
sounds and
the
temperature
display
flashes.
Has the appliance door been open for
longer than 60 seconds? If not, then the
temperature has risen higher or fallen
lower than the temperature that has been
set. This could be due to:
• The appliance door being opened too
often.
• The ventilation opening being covered
or too dusty.
• A lengthy interruption to the power
supply.
• A large number of bottles have been
added to the unit.
If yes, close the door.
• Do not open the door more often than
necessary.
• Clear the obstructions and wipe off
the dust.
• Leave the appliance to work for a
while until the set temperature has
been reached.
The icon “--”
is lit up and
flashing in the
temperature
display.
• The display temperature is out of
range.
• Only temperatures within the range
0~99°F/-9~37°C can be displayed. If
the temperature is not within this
range, the icon “--” will be displayed
instead. This is normal.
Loading ...
Loading ...
Loading ...