Loading ...
Before you start...
Your safety and the safety of others
isvery important.
We haveprovided manyimportant safety messages
in this manualandon your appliance.Always read
and obeyall safety messages.
This is the safety alert symbol. This symb01
alerts you to hazardsthat can kill or hurt
you and others. Aii safety messageswili be
precededby the safetyalert symbol andthe word
"DANGER"or "WARNING"=Thesewords mean:
Youca_ be killed or seriously injuredif you don't
f0H0w instructions.
All safety messageswill identify the hazard,teii you
how to reducethe chance of injury, and teli you
what can happenif the instructions are not
followed.
Proper installation is your responsibility. Make
sure you have everything for correct installation.
it is the responsibility of the installer to comply
with the installation clearances specified in these
instructions.
Cooktop installed over oven installation: Only
certain specified cooktop and oven models are
approved for cooktop over oven installations.
Cooktops approved for this type of installation
will have an approval label located on the outside
of the burner box. if you do not find this label,
contact your dealer to confirm that cooktop is
approved. The label on the bottom of your
cooktop lists the cooktop and oven combinations
that are approved for this type of installation.
Ovens approved for this type of installation will
have an approval label located on top of oven. if
you do not find this label, contact dealer to
confirm that oven is approved. Refer to oven
manufacturer's installation instructions for
approval for built-under use and proper cutout
dimensions.
When installing cooktop over a built-under
oven, Do Not fasten cooktop to countertop with
clamps. Cooktop then will be easy to remove if
servicing is ever necessary.
Check location where cooktop will be installed.
The location should be away from strong draft
areas, such as windows, doors and strong
heating vents or fans. The cooktop should be
located for convenient use in the kitchen.
Grounded electrical supply is required. See
"Electrical requirements," Panel B.
Jraportant:
Observe all governing codes and ordinances.
Failure to meet governing codes and
ordinances could lead to fire or electrical
shock.
When installing a cooktop under existing
cabinets and the installation does not meet the
minimum cabinet clearances. Install a range
hood above the cooktop to avoid burn hazards.
Countertop opening diraensions that are
shown must be used. Given dimensions are
minimum clearances and provide required 0"
(0 cm) clearance.
New installations -- follow minimum
dimensions given.
RepJaceraent installations -- Be sure that
front edge of cooktop is at least 1-1/2"
(3.8 cm) back from front edge of countertop.
Jt is the customer's responsibility:
To contact a qualified electrical installer.
To assure that the electrical installation is
adequate and in conforraance with National
Electrical Code, ANSItNFPA 70 -- latest
edition**, or CSA Standards
C22.1-94, Canadian Electrical Code, Part 1
and 022.2 No. O-[W91- latest edition *** and all
local codes and ordinances.
Product dimensions
30" (7&2 cra} or ..........
.___-36" (gl.4 cra} width
X
\
21" (83,3 era} depth
30" (76.2 era) or
........... 36" (91.4 cra) width
2W/8" (7.3 cra)
burner box
height
both sides
21o5/16" (54.t era) depth
-----T
2=314" (7.3 cra)
burner box
height
Cutout dimensionstrequirements
18" (4S,7 cra) rain.
dearance upper
cabinet to countertop
within minimum
clearances to cooktop
\,
\
Do not seal
cooktop to
countertop.
* Note: 24" (el cra) rain.
clearance if bottom of wood or
raetal cabinet is protected by
not less than 114" (O.Oera}
flame retardant raHIboard
covered with not Jess than No.
28 MeG sheet steet, 0.015"
(0.04 era} stainless steel, or
0.024"(0.08 cra) alurainura or
0.020" (O.OScra) copper.
30" (7&2 cra) rain. c{earance
between top of cooking
platforra and bottom of
unprotected wood or raetal
cabinet.
recoraraenaeo / I
clearances, upper cabinet
depth
@
20o1/2';
($2cra)
Junction bow
12" (3O.S era) [_
or more above
LJ
floor and 10"
(25.4 era) from
right side of
cabinet.
Y
1" (2.5 cra) rain. distance to
nearest _eft and right side
eorabustibie surface above
eooktop.
Cooktop width A B
30" 29=1/2" 30"
(76.2 cm) (75 cm) (76.2 cm)
36" 35-1/2" 36"
(91.4 cm) (90.2 cm) (91.4 cm)
36" (91,4 cra) or 30" (76.2 cra) rain. base
cabinet is required. Jfcabinet has a drawer, a
3" (7.5 cm) depth clearance from the countertop
to the top of the drawer (or other obstruction) in
the base cabinet is required.
Tools needed for installation:
Copies of the standards listed may be obtained from:
** National Fire Protection Association
Batteryraareh Park
Quincy, Massachusetts 02269
*** Canadian Standard Association
178 Rexda_e Boulevard
Etobicoke, (Toronto), Ontario Mew tR3
Panel A
Loading ...
Loading ...
Loading ...