Loading ...
Loading ...
Loading ...
PREPARATION
UNPACKING INSTRUCTIONS
The mower was fully assembled at the factory.
When the mower was put In the carton, the
handle was put in the storage position. To put
the handle inthe opiating position, follow the
steps below.
1. Remove the mower from the carton.
2. Putthe lower handle Inthe operating pesl-
tlon. Make sure the lower handle Is be-
twsen the Iocldng tabs (Rgure 1).
3. Put the upper handle In the operating
position.Tightenthe wlngnuts.
CAUTION: Be careful when you fold or
raise the handle. Do not damage the
cables. Acablethet Is bent will not work
correctly. Before you use the unit, re-
plumea bent or damaged cable.
4. To aifash the renoll-stert gdp to the rape
guide, twist the rope through the rope
guide mounted on the dght side ofthe han-
dle (Figure 2).
NOTE: If you cannot sttach the
recoil-tort gdp becausetheropeIstoo
short, hold the engine stop lever
against the handle. Slowly pull the
recoil-start gdp.
Recoil-Start
Gdp
LowerHandle
Offset Hole
HOWTOADJUSTTHEHANDLEHEIGHT
The lower handle has two assembly pesi-
_iens. A HIGH and a LOW position (Figure 3).
The HIGH pcalUon will raise the handle ap-
proximately four inches.
f
Figure
The mounting holes Inthe lower handle are
offset (Figure 1). To change the hole offset, ro-
tate the lower handle. This will change the
F-g852g
11
angle of the handle end make the height of the
handle higher or lower (Figure 3).
Removethe cabletias thst festen the€on-
trol cables to the lower handle (Figure 4).
The cable tin can be re-used. To remove
a cable tle, pull the tab onthe cable tle to
free the cable.
2. Remove the bolts and wlngnots that fas-
ten the upper handle tothe lower handle.
3. Putthe upper handle onthe groundbe-
hind the mower.
CAUTION: Do not bend the control
cables. A cable that Is bent or damaged
must be replaced.
4. Remove the wlngnutsfrom the dght end
left handle brackets (Figure 1).
5. Remove the lower handle from the han-
dle breoksta (Figure 1).
Loading ...
Loading ...
Loading ...