Loading ...
Loading ...
Loading ...
8
1886
Ceiling Bracket Downrod Hanging Fan Wiring Canopy Blades Light Glass/Bulbs Remote
Installing the Bulbs and Glass
Install the included bulbs into the
sockets. When necessary, replace
with bulbs of same wattage.
Rest the globe in the globe retainer. Lift the globe assembly and align
the screw holes of the globe retainer
with the screw holes with upper
switch housing.
Install the three globe retainer screws, found
in the
hardware bag. Tighten all three
screws.
WARNING
GLASS FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make
sure that glass is properly secured.
Assembling the LIght Kit
Partially install switch housing
screws, found in the
hardware
bag, halfway into the motor housing
as shown. It does not matter which
two screw holes you choose.
WARNING
FAN FALL HAZARD
Make sure all screws are tight to secure
the light xture.
2 of 3
Switch
Housing
Screw
BAG
Connect the plugs from the upper and lower
switch housings. Make sure to line up the colored
markings on the connectors. Lift the lower switch
housing until its screw holes are aligned with the
screw holes in the upper switch housing.
Install
the two light kit screws, found in the
hardware bag.
Tighten both screws.
Feed the wire plug through the center
hole of the upper switch housing,
then wrap keyhole slots around the
screws and twist counterclockwise.
Insert the third screw, found in the
hardware bag, into place and then tighten
all three screws.
BAG
x3
Globe
Retainer
Screws
Fan style may vary.
Note:
Fan style may vary.
Note:
2 of 2
Light Kit Screw
BAG
1 of 3
Switch
Housing
Screw
BAG
Loading ...
Loading ...
Loading ...