Loading ...
Revised 6/11/18 Copyright © 2018 Trade-Wind Manufacturing, LLC Proverbs 22:29 Page 2
CAUTION: For General Ventilation Use Only. Do Not Use To Exhaust Hazardous or
Explosive Material and Vapors.
CAUTION: This unit has an unguarded impeller. Do not use in locations readily accessible to people or
animals. WEAR HAND PROTECTION AND STAY CLEAR OF SHARP EDGES! The compactness and
adaptability of the model PSD blower permits easy installation. The units are shipped fully assembled
and can be mounted at any angle. For mounting suggestions see Page 3 & 4. Because this unit has
rotating parts, safety precautions should be exercised during all phases of installation, operation and
maintenance. Remove unit from package and inspect before installation. If damaged, report damage to
carrier. DO NOT operate this unit with visible damage to the blower or impeller assembly. Screen
guards must be installed when blower will be within reach of personnel, within (7) feet of the working
area, or when advisable for safety.
WARNING! DO NOT CONNECT POWER SUPPLY until blower is completely installed.
Make sure electrical service to the blower is locked in “OFF” position.
Check voltage at blower to see if it corresponds to the motor name plate. Installation work and
electrical wiring must be done by qualified person(s) in accordance with all applicable codes and
standards, including fire-rated construction.
Sufficient air is needed for proper combustion and exhausting of gasses through the flue (chimney) of
fuel burning equipment, (e.g., gas water heater, gas furnace) to prevent back drafting.
Follow the heating equipment manufacturer’s guideline and safety standards such as those published
by the National Fire Protection Association (NFPA) and the American Society for Heating,
Refrigeration and Air Conditioning Engineers (ASHRAE) and the local code authorities.
When cutting or drilling into wall or ceiling, do not damage electrical wiring and other hidden utilities.
Ducted blowers must always be vented to the outdoors.
If this unit is to be installed over a tub or shower, it must be marked as appropriate for the application
and be connected to a GFCI (Ground Fault Circuit Interrupter) –protected branch circuit.
NEVER place a switch where it can be reached from a tub or shower.
All units are suitable for use with solid-state speed control.
WARNING! TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO
PERSONS, OBSERVE THE FOLLOWING:
Sufficient air is needed for proper combustion and exhausting of gasses through the flue (chimney) or fuel
burning equipment to prevent back drafting. Follow the heating equipment manufacturer's guideline and safety
standards such as those published by the National Fire Protection Association (NFPA) and the American
Society for Heating, Refrigeration and Air Conditioning Engineers (ASHRAE) and the local code authorities.
When cutting or drilling into wall or ceiling, do not damage electrical wiring and other hidden utilities.
Duct blowers must always be vented to the outdoors.
Loading ...
Loading ...
Loading ...