Loading ...
Loading ...
Loading ...
m_WARNINu:If received assembled,
review all assembly steps to ensure your unit
is properly assembled and all fasteners are
secure.
TUBE ASSEMBLY
Upper Locking Sleeve Assembly
Wires
/
Lower Locking Sleeve Assembly
1. Align upper tube groove with triangle on
lower locking sleeve assembly. Push
tubes together until they snap into place.
Upper Tube
G reeve ... IC_ <_::::::::::_
Alignment Triangle
2. Try to pull tubes back apart. If the tubes do
not come apart, they are properly snapped
into place. If the tubes come apart, repeat
step 1 and push until the tubes snap into
place.
3. Slide upper locking sleeve assembly over
lower locking sleeve assembly and tight-
en by turning clockwise.
4. Ensure locking sleeve assembly and
alignment decals appear as illustrated be-
low.
d=:BWARNINu: The upper and lower
tubes must be snapped together, remain per-
manently assembled together and the locking
sleeve assembly must be fully tightened be-
fore and during use to avoid serious injury to
the operator and/or damage to the unit. DO
NOT attempt to disassemble unit after initial
assembly.
ADJUSTING ASSIST HANDLE
1. Loosen and remove wing nut and bolt
from assist handle.
2. Place unit on a flat surface.
3. Firmly push the assist handle over the
tube. To make installation easier, tilt han-
dle toward trigger housing while pushing
down (see illustration).
4. Reinstall bolt in handle. Thread wing nut
onto bolt.
5. Adjust the handle up or down the tube to a
comfortable position; tighten wing nut se-
curely.
_X Assist handle
Trigger \\ '_.
housing _,Sy_/ _
- _ _ _/Tube
ATTACHING EDGE GUIDE AND
SHIELD
WARNING: The shield must be prop-
erly installed. The shield provides partial protec-
tion to the operator and others from the risk of
thrown objects. Your unit is equipped with a line
limiter blade, which cuts excess line to the prop-
er length while running. The line limiter blade (on
underside of shield) is sharp and can cut you.
NOTE: If shield is not properly installed, dam-
age to unit (including motor failure) will result.
1. Insert edge guide into two holes in shield.
NOTE: Edge guide must be positioned on
shield prior to installation on motor housing
(see following illustration).
Edge Guide Front
Locking
L.-- Tab
Rear Lockinc
Tabs
/
Alignment decals
Z_
WAR NING: Failureto completelyen-
closeexcess wires in upper tube during assem-
bly of the unit may result in damage to the wires
and/or the unit or serious injury to the operator
including electrocution.
2.
Shield
Place shield over cutting head at an angle
to the motor housing. Insert front locking
tab on shield into opening in front of motor
housing.
Loading ...
Loading ...
Loading ...