Islandaire EZ2612A2C1S41AA Installation Instructions and Owner's Manual

Loading ...

YOU WILL SEE

TO OPERATE ON FAN ONLY:

DO THIS:

35(66

02'( %87721

&+226(

)$121/<

LIGHT ON

1RWH8VHWKLVIXQFWLRQRQO\ZKHQFRROLQJLVQRWGHVLUHGVXFKDVIRUURRPDLr circulation. You can choose any fan speed you prefer,

EXCEPT AUTO FAN.'XULQJWKLVIXQFWLRQWKHGLVSOD\ZLOOVKRZWKHDFWXDOFXUUHQW

WHPSHUDWXUHQRWWKHVHWWHPSHUDWXUHDVLQWKHFRROLQJPRGH.

TO USE THE

ENERGY SAVER FEATURE:

LIGHT ON YOU WILL SEE

DO THIS:

35(66

02'(%877

&+226(

(1(5*<6$

9(5

TIMER-DELAY YOU WILL SEE

FIRST DO THIS:

35(667,0(5 BUTTON

THEN

DO THIS:

35(667(037,0(5

%87721

THE TIME CHOSEN:

START/STOP FEATURE:

LIGHT ON

1RWH)RU'HOD\6WRSWKHXQLWPXVWEHLQWKH21SRVLWLRQ

1RWH)RU'HOD\6WDUWWKHXQLWPXVWEHLQWKH2))SRVLWLRQ

1RWH,QWKLVPRGHWKHIDQZLOOFRQWLQXHWRUXQIRUa short time after the compressor cycles off.

To adjust timer setting, tap or hold the UP arrow (^) or DOWN arrow (v) to change the delay time by 0.5 hour increments up to 10 hours,

then by 1 hour increments up to 24 hours. The control will count down the timer remaining until start (8, 7.5, 7, etc.). After

set Timer,the unit will enter into Timer mode by 5 seconds, then Timer light on, Set light off. In Timer mode: Set temperature

and fan speed keeps previously set temperature and fan speed; Temperature display set temperature, no display if power

turn off; Press Timer once, LED display remaining time of set time, LED return to set temperature by 5 seconds;

When in Fan Only mode, LED only display room temperature, do not display set temperature.Turning the unit "ON" or

"OFF" at any timer will cancel the

Delay Start/Stop function. The delay Start/Stop feature will work until the unit either starts

or stops. Once this has happened then the above steps have to be repeated again.

COOLING FEATURE (on some models):

YOU WILL SEE

DO THIS:

35(66

02'(%877

6(/(&7COOL

Note：This feature can be used with any combination of FAN Speeds, Timer, or Sleep Modes. When in the “Cool” Mode, the fan will

run continuously while cool is needed. The temperature will automatically be maintained anywhere between 61°F (16°C) and 86°F

(30°C). When the room set temperature is satisfied, the fan will cycle off and on to circulate and sample the room air. If the air conditioner

is off and is then turned on while set to a Cool setting or if turned from a fan setting to a Cool setting, it may take approximately 3 minutes

for the compressor to start and cooling to begin.

Air Conditioner Features

(continued)

Loading ...

Islandaire EZ2612A2C1S41AA EZ 26 Series Electric Heat Wall Air Conditioner

Installation Instructions and Owner's Manual - Page 13