Loading ...
Loading ...
Loading ...
8 | P a g e
1.6 RESPONSIBILITY OF THE CUSTOMER
Ensure that the electrical outlet is connected effectively to earth (ground), suitable to provide
the voltage indicated on the data plate. Make sure that the cooler is placed on a level surface.
2. TECHNICAL DATA
2.1 MATERIALS AND REFRIGERANTS
Interior or exterior surfaces that come into contact with the product are made of steel,
aluminium or non-toxic plastic materials. The refrigerant used is approved by government
regulations.
The type and quantity of the gas charged, in the refrigeration unit, is indicated on the data
plate, this unit is R600A.
3. INSTALLATION
For safe proper operation, follow the manufacturer’s instructions reported in this section.
3.1 POSITIONING
IMPORTANT NOTE: Coolers that have been tilted MUST remain in the upright position for 24
hours prior to plugging in the cooler, the cooler is built in style so can go under benches, front
grill must be clear. Keep away from heat sources, such as radiators or air conditioning pipes.
Allow free air circulation to the refrigerator unit if you have option, this can help lessen run
times.
The installation instructions furnished with the device indicate a clearance of min 10mm at
top, 100mm at the rear and min 10mm at each side.
Do not place unit in sunlight or behind a cupboard door.
The appliance should be placed where the ambient temperature is between 10 – 38 degrees
Celsius for optimum performance. If the ambient temperature is above or below this range,
the performance of the unit may be affected. Placing your unit in extreme cold or hot
conditions may cause interior temperatures to fluctuate.
The shelf can withstand the maximum load 50kg (all glass bottles)
3.1.1 COOLER LEVELLING
To provide the best performance the cooler must remain level.
Loading ...
Loading ...
Loading ...