BRUC5G Instructions for the Use and Care and Installation

Loading ...

BLUE = N neutral

If not provided, connect a plug for the electrical load indicated on the rating label. Where a plug is provided,

the rangehood hood must be installed in order that the plug is easily accessible.

An omnipolar switch with a minimum opening of 3mm between contacts, in line with the electrical load and

local standards, must be placed between the appliance and the network in the case of direct connection to

the electrical network.

Warning: Failure to install the screws or xing device in accordance with these instructions

may result in electrical hazards (see technical data if supplied).

• Installation

The following instruction should be followed to carry out the correct installation of the rangehood .

1) Mounting of the rangehood on the lower side of the cupboard.

2) Choosing the version (extractor, g. 1A, or lter, g. 1B).

• Fixing the hood to the lower part of the wall cabinet

This type of appliance must be tted inside a cabinet or inside another type of support structure. The overall

measurements of the rangehood are given in gure 2. Before proceeding with rangehood installation, remove

grille D by pressing the two side buttons A, as shown in gure 3. Fix the appliance in place using 8 screws (not

supplied) which are suited to the type of cabinet. To install the rangehood correctly, rst t the 4 screws A and

then the 4 screws B, in accordance with the diagram in gure 4.

After xing the rangehood to the lower part of the cabinet, place grille D (g. 4) back in the correct position.

During this procedure, make sure that grille D is fastened properly.

• Extraction through an outside wall

The appliance expels the fumes through an outside wall or a duct.

It is necessary to buy a telescopic pipe in accordance with the standards in use (inammable) and connect it

to ange H (Fig 1A).

• Recirculation

To transform an ducted rangehood version into a recirculating version, contact your appliance dealer and ask

for charcoal lters. The lters should be tted to the extraction assembly inside the rangehood, by centring

them and rotating them 90 degrees, until they click into place (g. 6).

To perform this operation, rst remove grill D (g. 3). The air is released back into the room through air exhaust

piping which passes through the cabinet and is connected to ange H (g. 1B).

- 7 -

Loading ...

Blanco BRUC5G 53cm Under Cupboard Rangehood