Loading ...
Loading ...
Loading ...
Installation Instructions
4_ FASTEN THE SHUTOFF VALVE
Fasten the shutoff valve to tile cold water pipe with
the pipe clamp.
PipeClamp
Saddle-Type
ShutoffValve
VerticalCold
WaterPipe
NOTE: Commonwealtb of Massachusetts Plumbing
Codes 248CMR shall be adhered m. Saddle valves
are illegal and use is not permitted in Massachusetts.
Consuh with your licensed plumben
5_ TIGHTEN THE PIPE CLAMP
Tighten the clamp screws until the sealing washer
begins to swell.
NOTE: Do not overtighten or you may crush the
tubing.
Washer
PipeClamp-- --inlet End
Clamr
6_ ROUTE THE TUBING
Route the tubing between the cold water line and
the refrigerator:
Route the tubing through a hole drilled in the wall
or floor (behind the refrigerator or adjacent base
cabinet) as close to the ,a-all as possible.
NOTE: Be sure tbere is sufficient extra tubing
(about 8' [2.4 m] coiled into 3 turns of about 10"
[25 cm] diameter) to allow the refrigerator to move
out fl'om the wall after installation.
[]
CONNECT THE TUBING
TO THE VALVE
Place the compression nut and ferrule (sleeve)
for copper robing onto the end of the tubing and
connect it to the shutoffvalve.
Make sure the tubing is fully inserted into the valve.
Tighten the compression nut securely.
For plastic tubing from a GE SmartConnect'"
Refl'igerator Tubing kit, insert tbe molded end
of the tubing into tbe shutofl'valve and tighten
compression nut until it is hand-tight; then tighten
one additional turn with a wrench. Overtightening
may cause leaks.
=ression
Nut
Saddle-Type--\
ShutoffValve SmartC°nnect'_
Jbing
Packing
/
OutletValve_
Ferrule (sleeve}
NOTE: Commonweahh of Massachusetts Plumbing
Codes 248CMR shall be adhered to. Saddle valves
are illegal and use is not permitted in Massachusetts.
Consuh with your licensed plumben
[] FLUSH OUT THE TUBING
Turn the main ,a-ater supply on and flush out the
tubing until the water is clear.
Shut the water offat the water valve after about
one quart (1 liter) of water has been flushed
tbrough the tubing.
17
Loading ...
Loading ...
Loading ...