Loading ...
Loading ...
Loading ...
INSTALLATIONREQUIREMENTS
Gather the required tools and parts before starting installation.
Read and follow the safety instructions provided with any tools
listed here.
Tools needed:
level
drill with 11/4"and %2" drill bits
pencil
wire stripper or utility knife
measuring tape or ruler
pliers
caulking gun and weatherproof caulking compound
duct tape
jig saw or keyhole saw
flat blade screwdriver
metal snips
Phillips screwdriver
Parts needed:
3/4"(19.0 mm) UL- or CSA-listed strain relief
power supply cable
metal vent system
IMPORTANT: Observe all governing codes and ordinances.
Hood location should be away from strong draft areas, such as
windows, doors and strong heating vents.
Installation clearance dimensions that are shown must be used.
Given dimensions provide minimum clearance.
NOTE: Hood liner must be surrounded by a custom built
enclosure.
Cooktop to hood clearance wilI depend on the material the
builder uses to enclose the liner.
Grounded electrical outlet is required. See "Electrical
requirements" section.
It is recommended that the hood be fastened to solid wood.
The hood is factory set for venting through the roof or wall.
All openings in ceiling and wall where the hood will be installed
must be sealed.
Installation Clearances
min, cabinet opening widths:
36" (91.4 cm) model, 36" (91.4 cm)
48" (121.9 cm) model, 48" (121,9 cm)
hood support must be capable of
supporting 40 Ibs. (18,1 kg) for |
36" (91,4 cm)modelor55Ibs,(25 kg) |
for48"(121,9 cm) model recommended24"to 36"
(61,0 cmto91.4cm)
above cooktop
hood liner is
22' (55.9 cm)
deep
Loading ...
Loading ...
Loading ...