Loading ...
Loading ...
Loading ...
Filter Assembly
1. Locate the filter, filter plate and filter
nut.
2. Carefully slide the filter over the filter
cage, sliding it over the center ring cov-
ering the 3 notched areas until the filter
stops against the lid.
3. Place the hole in the filter plate over
threaded screw of the filter cage.
4. Gently push on the filter plate to seat
the rubber ring of the filter inside the cir-
cular channel of the filter plate.
5. Place filter nut onto threaded screw and
tighten it down. Finger tighten only.
NOTE: Lever of filter nut should be away
from plate as shown.
IMPORTANT: Do not overtighten as this
may deform or crock the filter plate, filter
cage or the filter.
NOTE: Your filter has a redstdpe that
matches an in-store dispLayer.When you
visit your local Sears store, just remember
the color of your stripe for the correct size
filter.
Power Filter
Assembly,,,_ Cage
Caster/Caster Foot Assembly
1, Remove the power assembly from the
dust drum and set aside.
2.Turn the dust drum upside down on the
floor.
3. Insert the caster feet into the bottom of
drum, as shown (4 places).
4. Push on the caster foot until the foot
rests against the first step of the dust
drum,
5. Insert the caster stem into the socket of
the caster foot, as shown (4 places).
6. Push on the caster until the ball on the
caster stem is inserted all the way into
the socket. You will hear the ball snap
into the socket and the caster will swivel
easily when positioning is correct.
7. Turn the drum upright.
(_C caster
aster Stem
Caster Ball
I
I
Dust Drum
6
Loading ...
Loading ...
Loading ...