Loading ...
Loading ...
Loading ...
6 49-55125-1
ENGLISH
USING THE DISHWASHER
START DISHWASHER
Start Press the Start pad and close the door within 4 seconds to start the cycle or begin the Delay Start
countdown. The Start light will turn on. The wash cycle will begin after 10 seconds and then pump out for
60 seconds prior to filling the dishwasher with water. To activate the display, press any pad with the door
open.
Interrupt
or Pause
To interrupt or pause a cycle, slowly open the door. Opening the door will cause the wash cycle to pause.
The dishwasher will beep every minute to remind you to close the door. To restart or resume the cycle,
press Start, and close the door within 4 seconds. If the door is not closed within 4 seconds, the Start light
will start blinking and the dishwasher will beep once every minute to signal that the cycle did not restart. If
the Start light is blinking, the dishwasher is waiting for input.
Cancel To cancel a wash cycle, press and hold the Start pad for 3 seconds and close door.
The dishwasher will dr
ain, emit a beep sound, and the wash cycle light will turn off.
6
INDICATOR LIGHTS
Sanitized Displayed at end of the cycle when Wash Temp - Sanitize has been selected and dishwasher has met
requirements for sanitization. See Wash Temp - Sanitize, for complete description. Opening the door will
turn off the light.
Clean Displayed when a wash cycle is complete. The light stays on as a reminder that the dishes are clean.
Opening the door will turn the light off.
DISPLAY
Time
Remaining
During operation, the display shows the total number of minutes remaining in the cycle. During a delay
start, the display will show hours of time remaining until the cycle starts.
7
8
CHECK THE WATER TEMPERATURE
The entering water should be at least 120°F (49°C) and not
more than 150°F (66°C) for effective cleaning and to prevent
dish damage. Check the water temperature with a candy or
meat thermometer.
Turn on the hot water faucet nearest the dishwasher,
place the thermometer in a glass and let the water run
continuously into the glass until the temperature stops rising.
SABBATH/DOOR WAKE UP MODE
To turn this option ON/OFF, press and hold the Start and
Wash Temp buttons for 5 seconds, close the door and wait 3
minutes for the dishwasher to go into sleep mode. In the OFF
mode, the control display, control sounds, and interior lights
(on some models) will not respond to the door opening/
closing. This mode can be used when observing certain
religious holidays such as the Sabbath. To activate the control
and interior lights (on some models), press any button.
DISPENSERS
Use a Rinse Agent
Rinse agents, such as Finish® Jet-Dry® Rinse Aid are
designed for great drying action and to protect against spots
and film build-up on your dishes, glasses, flatware, cookware,
and plastic.
Filling the Rinse Agent Dispenser
The rinse agent dispenser holds 3.9 oz. (115 ml) of rinse
agent. Under normal conditions, this will last approximately
one month.
1
Make sure the dishwasher door is fully open.
2
Open the dispenser door. (Rinse agent compartment is
on the right side of dispenser.)
3
Slowly add rinse agent until the cup is full. You may need
to pause several times to allow rinse aid to settle.
4
Clean up any spilled rinse agent with a damp cloth to
prevent foam from forming inside the dishwasher.
5
Close the dispenser door.
Loading ...
Loading ...
Loading ...