Loading ...
Loading ...
Loading ...
L
I
G
H
T
I
N
G
I
N
S
T
R
U
C
T
I
O
N
S
F
I
G
1
1
F
I
G
1
2
M
A
T
C
H
H
O
L
D
E
R
L
O
C
A
T
I
O
N
Lighting the Grill Burner
Note: Open the grill lid before lighting. Turn all knobs to “OFF”. Turn the main gas supply on. If you smell gas, shut-off the gas supply and call for
service.
1. Press and hold the selected burner knob and turn it to “HIGH” while continuing the hold the knob pressed in. You will hear the burner igniter begin to
make a clicking sound
2. The burner will ignite within 4-5 seconds. When the burner is lit the clicking sound will stop.
3. Continue to hold the knob pressed in for 5-10 seconds. This allows the safety system to heat and sense the burner flame and remain lit.
4. If the knob is released before the safety system is hot the flame will extinguish. If this occurs, restart the lighting process at Step 1
5. If the burner does not ignite within 5 seconds and you smell gas, turn the burner knob to the “OFF” position and wait 5 minutes to allow any
accumulated gas to dissipate before attempting to re-light the burner.
6. If the flame goes out during use and there is gas available the ignition system will begin clicking again and will automatically re-ignite the burner. If
there are windy conditions the burner may click periodically which is normal.
7. If the flame goes out or windy conditions move the flame too much the safety system will shut off gas to the burner. If this occurs, wait 5 minutes and
until the windy conditions reduce and relight starting at Step 1
Match or Butane Lighting Method
CAUTION: Keep your face and hands as far away from the grill as possible when manually lighting burners.
In the event of a power failure or if a burner igniter is damaged, the grill can still be used. If an attempt has just been made to ignite a burner, wait 5
minutes and follow the procedure below:
1. A match holder is provided and located in the drip tray slide out section of the Grill on the right hand side.
2. Separate two grate sections above the desired burner as shown in Fig. 12 to allow access to the ignition area.
3. Using the match holder provided, securely place a match in the clip side of the holder.
4. Ignite the match and insert it between the separated grates. Place the flame of the match close to one of the holes of the desired burner.
5. Press and hold the selected burner knob and turn it to “HIGH” while continuing the hold the knob pressed in.
6. The burner will ignite within 4-5 seconds.
7. Continue to hold the knob pressed in for 5-10 seconds. This allows the safety system to heat and sense the burner flame and remain lit.
8. If the flame goes out during use the safety system will turn the gas to the burner off.
Loading ...
Loading ...
Loading ...