ASSEMBLING & INSTALLATION INSTRUCTIONS
The drawing shown may not exactly match the product enclosed.
However, the installation instructions do apply to this product.
4226 4227
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR.
ASSEMBLING THE FIXTURE (Fig.1)
1. Shut off the power at the circuit breaker box. Remove old fixture and all
hardware from Junction Box. Carefully unpack your new fixture and lay out all
the parts on a clear area. Take care not to lose any small parts necessary for
installation.
2. Slide the electrical wires through the pipe(L)/(K)/(J), ring(I) and canopy(G).
Raise the pipe(L) to top coupling of lamp body(M), by turning it clockwise until
tight. Raise the pipe(K)/(J) and ring(I) onto the end of pipe(L), by turning it
clockwise until tight.
3. Attach the canopy(G) onto the pipe nipple of the pipe(J) and lock it securely
with the lock washer and hex nuts(F).
4. End of pipe nipple screw(C) into single bar (D), place lock washer (B) over end
of nipple protruding through single bar and lock it securely with the hex nut
(A). Take this single bar assembly to junction box with junction box screws (E),
tighten screws securely with screwdriver. The side of the single bar marked
"GND" must face to out. The junction box is not included.
5. While holding the fixture body towards the ceiling, connect the electrical wires
as Shown in Fig.2, making sure that all wire nuts are secured. You may have
to wrap the connections with electrical tape. If your outlet has a ground wire
(green or bare copper), connect the fixture ground wire to it. Otherwise
connect fixture’s ground wire directly to the Single bar with the green screw
provided. After wires are connected, tuck them carefully inside the Junction
Box.
6. Raise the fixture body on to the Junction box, aligning screws on single bar
with mounting hole in canopy and lock it securely with the finial (H). Attach the
glass(N) to the lamp holder and lock it securely with the check ring(O).
7. Install the light bulbs(Not included) in accordance with the fixture’s
specifications. NOTE: DO NOT EXCEED THE SPECIFIED WATTAGE!
Your installation is now complete. Return power to the junction
box and test the fixture.
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black(Hot)
FIXTURE
WIRES
White or
Ribbed
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
White
(Neutral)
HOUSE
WIRES
Green or Bare
Copper(Ground)
Thank you for purchasing a LIVEX product.
Need assistance with parts or assembly? Please call customer service at: 800-761-8056
Or visit us online at: WWW.LIVEXLIGHTING.COM
©COYRIGHT ALL RIGHTS RESERVED.LIVEX LIGHTING,INC. DOC20160204226
FIG.2
