Loading ...
Loading ...
damageisnotcoveredunderthewarranty.Ifyoususpect
yourvoltageishighorlow,consultyourpowercompany
fortesting.
Topreventtheappliancefrombeingturnedoff
accidentally,donotplugtheunitintoanoutletcontrolled
byawallswitchorpullcord.
DONOTpinch,knot,orbendthepowercordinany
manner.
Other Precautions
• NEVER unplug the appliance by pulling on the power
cord. Always grip the plug firmly and pull straight out from
the receptacle.
To avoid electrical shock, unplug the appliance before
cleaning.
NOTE: Turning the control to "OFF" turns off the compressor but
does not disconnect power to other electrical components.
Caster Installation and Set-up
Inspection for Damage
Inspect the underside of the cabinet and packaging for damage,
similar to what can be caused with a forklift. If hidden damage
is found after uncrating, immediately call the delivery carrier
and request an inspection. Retain all packaging and crating
materials until the inspection is complete.
Parts and Accessories
Check to make sure that you have received the box containing
all of the components listed below.
A Carriage Bolt (4) D Fixed Caster (2)
B Lock Nut (4) E Hex Screw (10)
C Swivel Caster (2)
A B
Tools Needed
C
E
The following tools are required to assemble and install the
casters to the unit:
5/16", 3/8" and 9/16" Adjustable Wrench Phillipsc_
Socket or Open End or Pliers Screwdriver
Wrench
Uncrating and Set-up
1. Remove carton and all loose parts from inside the unit.
2.
Remove the rear access guard and place it and the
screws in a safe place for reassembly later.
3.
Using an assistant, carefully tip the unit onto its back and
rest on blocks to avoid damaging the condensate drain
hose and the plastic raceway that covers the evaporator
tubing on the back of the cabinet.
4.
8.
6.
Remove the four scews holding the wood skid to the
bottom of the unit using a 3/8" socket wrench. See Figure
1. Discard the wood skid and screws.
Remove and discard the two front brackets with leg
leveler using a 5/16" socket wrench. See Figure 1.
FOR GLASS DOOR MODELS ONLY - Remove bottom
door support bracket and screw opposite the door hinge
using a 3/8" socket wrench. See Figure 2.
JJ
Figure 1
Screws
Wood Skid
Skid
Support Bracket
Figure 2
Loading ...
Loading ...
Loading ...