Loading ...
Loading ...
Loading ...
Most laundering problems are easily solved if you understand the cause.
Check these lists for common laundry and washer problems. If you need
further assistance, see the back page.
Problem Possible Cause Solution
Washer Leaks Household plumbing isleaking. Repair plumbing.
Inlet hoses not tight. Tighten hoses (see "Installation
Instructions").
Inlet hose washers not Reseat washers (see "Installation
properly seated. Instructions").
Drain hose not properly Clamp drain hose (see 'Installation
clamped or is off. Instructions").
Drain is clogged. Remove drain clogs. Sink, standpipe,
or floor drain must be ableto handle
17 gaI (64 L) of water per minute.
Tub moved forwardduring Ensure tub is centered before
unloading, causingwater to starting washer.
deflect off tub ring.
Unit not levelcausing water Ensure front feet are installedand
to deflect off tub ring. nuts aretightened. LeveIwasher.
Reset rear legs (see "Installation
Instructions").
Load is unbalanced.Spray Redistribute the load.
rinses are deflecting off load.
Washer is overloaded. Fills or Reduce load size.
spray rinses are deflecting off
load.
Won't Drain/ Drain hose is kinked or Straighten or unplug hose (see
Won't Spin/ clogged. "Installation Instructions").
Wet Loads
Correct operation of After awash or rinse, the washer will
neutral drain, drain without spinning. After draining,
the spinning begins.
Lid is open. Close the Iid.
Drain hose is more than Lower drain hose (see "Installation
96 in.(2.4 m) above floor. Requirements").
Too much detergent- Use Isss detergent.
excessive sudsing.
Wrong cycle forload Choose a cycle with a higher spin
being washed, speed (see"OperatingYour
Washer").
28
Loading ...
Loading ...
Loading ...