Loading ...
Loading ...
Loading ...
Do not remove any parts from the cooktop
until they have completely cooled and are safe
to handle. Do not operate the surface Burners
without the Burner Caps and Burner Heads
properly in place.
To Clean the surface Burner Caps and Burner
Heads= Use a soap-filled scouring pad or a mild abrasive
cleanser to clean the surface Burner Caps. The ports
(or slots) around the Burner Heads must be routinely
checked. If residue remains in these ports (or slots), use
a small-gauge wire or needle to clean the slots or holes.
For proper flow of gas and ignition of the burner--DO
NOT ALLOW SPILLS, FOOD, CLEANING AGENTS
OR ANY OTHER MATERIAL TO ENTER THE GAS
ORIFICE HOLDER OPENING, ALWAYS keep the
surface Burner Caps in place whenever the gas Burners
are in use or not.
To Clean the Burner Grates= Be sure burners and
grates are cool before you place your hand, a pot
holder, cleaning cloths or other material on them. The
cast iron burner grates can be washed in hot soapy
water. Rinse thoroughly and dry the grates with a cloth -
don't put them on the cooktop while still wet. Be sure the
grates are positioned securely over the burners.
To remove burned on food, place the grates in a covered
container or plastic bag. Add 1/4 cup ammonia and soak for
30 minutes. Wash, rinse well and dry. An abrasive cleaner
can be used for stubborn stains.
To Clean the Cooktop and contoured areas of the
cooktop= Ifa spilloccurson the porcelaincooktop,
blotup spillwithan absorbentcloth.Rinsewitha clean,
damp clothand wipe dry.Do notuse harshabrasive
cleanerson the cooktop.They can scratchthe porcelain.
Completely rinse any mild cleaners used from the surface
or the porcelain cooktop may become damaged during
future heating. DO NOT use spray oven cleaners on the
cooktop.
CARE AND CLEANING OF STAINLESS
STEEL (Stainless Steel models only)
Some models are equipped with stainless steel exterior
parts. Special care and cleaning are required for
maintaining the appearance of stainless parts. Please
refer to the table provided at the beginning of the
General Care & Cleaning section in this Use & Care
Guide.
Before you call for service, review this list. It may save you time and expense. The list includes common
occurrences that are not the result of defective workmanship or materials in this appliance.
Surface burners do
not light,
Surface Control knob has not been completely turned to LITE. Push in and turn the Surface
Control knob to LITE until burner ignites and then turn control to desired flame size.
Be sure gas supply valve is open: .................................
Burner ports or slots are clogged. With the burner off, use a small-gauge wire or needle to
clean ports or slots.
Power cord is disconnected from outlet (electric ignition models). Be sure cord is plugged
securely into outlet.
....Be_ricai power outage iele_iic ignition modeiSi[ Burners can be lit manually: see se_ing
Surface controls in this Owner's Guide.
su_ace burner Burner p0_ or Slots are Clogged: With the burner off, clean p0_s with a small:gauge wire
flame burns half way or needle to clean ports or slots.
around, Moistureispresentaftercieaning:Lightiyranthe ameanda,owburnertoOperateuntii ame
is full. Dry the burners thoroughly following instructions under General Cleaning.
Surface burner flame Dust particles in main line. Allow the burner to operate a few minutes until flame turns
is orange, blue. ...............................
In coastal areas, a slightly orange flame is unavoidable due to salt air.
Loading ...