Loading ...
Loading ...
CAUTION! Avoid Injury or damage to the unit or other property
• Provide occasional ventilation during use. Do not direct affflow at fireplaces or other heat related sources as this could cause flare ups or make
units run excessively.
• Do not climb on or place objects on outdoor part of the unit.
, Do not hang objects off the unit.
• Do not place containers with liquids on the unit.
• Turn off the air conditioner at the power source when it will not be used for an extended period of time.
• Periodically check the condition of the unit's installation accessories for any damage.
• Do not apply heavy pressure to the radiator fins of the unit.
• Operate the unit with air filter in place.
• Do not block or cover the intake grille, discharge area and outlet ports.
Ensure that any electrical/electronic equipment is one yard away from the unit.
, Do not use or store flammable gases near the unit.
i
READTHIS SECTION BEFOREATTEHPTING TO OPERATEAIR CONDITIONER.
Unit must be upright for one hour prior to operating.
Operation of Current Device
Plug in & The power supply cord contains a current device that senses damage to the power cord. To test
press RESET
Remark: The appearance of actua_ plug may be
slightly different from the _ine drawing shown in
the figure. The _ine drawing is for reference only.
your power supply cord do the following:
1. P}ug in the Air Conditioner.
2, The power supply cord will have TWO buttons on the plug head. Press the TEST button. You will
notice a click as the RESET button pops out.
3. Press the RESET button. Again you will notice a click as the button engages.
4, The power supply cord is now supplying elec_tricity to the unit. (On some products this is also indi-
cated by a light on the ptug head).
, Do not use this device to turn the unit on or off.
' Always make sure the RESET button is pushed in for con-ect operation.
The power supply cord must be replaced if it fails to reset when either the TEST button is pushed,
or it cannot be reset. A new one can be obtained from the product manufacturer.
If power supply cord is damaged, it CANNOT be repaired. It MUST be replaced by one obtained
from the product manufacturer.
@2009 Electrolux Home Products, Inc. All rights reserved.
Loading ...
Loading ...
Loading ...