Loading ...
Loading ...
Loading ...
8
1886
Assembling the LIght Kit
Remove the tape from the pull chains from
the upper switch housing. Feed the wire plug
through the center hole of the upper switch
housing, then wrap the keyhole slots around
the screws and twist counterclockwise.
Partially install two light kit
assembly screws, found in the
hardware bag, halfway into
the motor housing as shown.
It does not matter which two
screw holes you choose.
2 of 3
Light Kit Screw
BAG
1 of 3
Light Kit Screw
BAG
2 of 2
2 of 2
Short Light Kit
Screw
Thumbscrews
BAG
BAG
Insert the third screw found in the ( ) hardware
bag, and rmly tighten all three screws. Connect
the plugs from the fan and upper switch housing.
Make sure to line up the colored markings on the
connectors and that the connectors latch.
Carefully push all switch housing components
into the switch housing, then install the switch
housing plate using two short light kit assembly
screws, found in the hardware bag.
Lift glass assembly along the pull chains
and align the two exposed glass assembly
holes with two holes in the upper switch
housing. Attach with thumbscrews found
in the hardware bag. Tighten all four
thumbscrews.
Ceiling Bracket Downrod Hanging Fan Wiring Canopy Blades Light Glass/Bulbs
Remove the plastic tab from the end of each pull
chain. Lift glass assembly and thread each pull
chain through the matching hole in the glass
assembly.
Attach the pull chain
pendants to the light and
fan pull chains. The pull
chains can now support
the weight of the glass
assembly so that you
may nish the light kit
installation.
Repeat x2
The fan pull
chain controls
the speed: from
high to off.
The light pull chain
controls the light
xture: on and off.
ON
T
urn P
o
w
er
Install the included bulbs into the
sockets. When necessary, replace
with bulbs of same wattage.
NOTE: Check to ensure
proper engagement.
WARNING
GLASS FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make
sure that glass is properly secured.
Fan style may vary.
Note:
WARNING
FAN FALL HAZARD
Make sure all three screws are tight to secure
the trim ring to the mounting plate.
Loading ...
Loading ...