Loading ...
Loading ...
Loading ...
9. Panel Adjustment (K-99572-TL and K-99573-TL)
CAUTION: Risk of product or property damage. Swinging panels that are misaligned or set too
close to the main mirror can chip or break. If needed, make adjustments to properly align the
panels with the main mirror.
NOTICE: Alignment of the swinging panels is set at the factory. Adjustments should not be necessary
unless the panels have been replaced.
Fold the swinging panel against the main mirror.
Loosen the lock screws on the top and bottom hinge approximately 1/4 turn clockwise.
Tight Gap Adjustment: Turn the jack screws counterclockwise in 1/4 turn increments at the top
and bottom of the mirror.
Tilt Adjustment: Turn the jack screw counterclockwise in 1/4 turn increments at the top or bottom
of the mirror, whichever has the tighter gap.
Height Adjustment: Turn the screw at the bottom of the mirror to raise or lower the swinging panel
to the same height as the main mirror.
Slowly unfold the panel and check alignment.
Repeat the adjustments as needed.
Care and Cleaning
For best results, keep the following in mind when caring for your KOHLER product:
NOTE: Periodic care and maintenance should include checking all hinge screws on the door to make sure
they are tight and engaged in the hinge holes.
•
Do not let cleaners sit or soak on surfaces.
Gap
Tilt
Height
Adjust the
tighter gap.
Jack Screws
Lock
Screws
Kohler Co. 13 1292979-2-A
Loading ...
Loading ...
Loading ...