Loading ...
Loading ...
Loading ...
6
Fix the upper chimney both in the right and in
the left side through the two screws supplied.
Warning: Failure to install the screws or xing
device in accordance with these instructions
may result in electrical hazards.
INSTALLATION
Before installing the appliance, make sure that
none of the parts is damaged in any way.
In case of damaged parts, contact your retai-
ler and do not proceed with installation.
Read all of the following instructions with
care before installing the appliance.
- Use an air outlet pipe of the shortest pos-
sible length.
- Limit the number of pipe bends.
- Use a material approved by standards and
regulations.
- Avoid any sudden changes in pipe section
(recommended constant diameter: 150 mm
or equal surface area).
* Before installing the appliance, in order not
to damage the appliance itself, the metal gra-
se lter should be removed. Such lter can be
removed by pushing the special lter handle
toward the back side of the cooker hood and
turning it downwards so to unfasten it from
its slot (Fig. 1).
Wall stirrup-xing.
* By using the special drilling jig (Fig. 2 X),
perforate the wall according to the pattern
indicated by the jig itself, and pay attention in
order not to damage water pipes and electric
wires. Perforation should be performed with
a Ø 8 mm wall-drill. Then insert into the
proper plastic reinforcements (Fig.2 A). The
hood-bearing stirrup (Fig. 2 S) can be applied
by using the screws provided with the equi-
pment (Fig.2 B). Now hook the cooker hood
onto its bearing (Fig.3) and then adjust hori-
zontally and vertically the position of the ap-
pliance by acting on the special metric screws
(Fig. 4 V,T).
Fixing the ornamental chimney
* Before xing the chimney, place the electric
feeding equipment into the ornamental pipe
and provide it with a hole for the air outlet if
the appliance is used in its sucking version.
Fix the supporting bracket of the chimney to
the wall or to to ceiling (g. 5), install both
chimneys in their suitable place above the
hood, then lift the upper chimney (the inter-
nal one) until it reaches the supporting brac-
ket, previously installed.
Loading ...
Loading ...
Loading ...