Loading ...
Loading ...
Loading ...
page 6
7. Canopy Assembly.
Locate 2 screws on underside of hanging bracket
and remove screw closest to the open end of the
hanging bracket. Partially loosen the other screw.
Lift canopy to hanging bracket. Place rounded
part of slotted hole in canopy over loosened
screw in hanging bracket and push up. Twist
canopy to lock. Re-insert screw that was removed
and then tighten both screws securely.
Slide canopy cover up to canopy, aligning
rounded part of slotted holes in canopy cover
with screw heads in bottom of canopy. Turn
canopy cover to the right (clockwise) until it
stops.
canopy
screw
canopy cover
hanging bracket
screw
8. Blade Assembly.
motor housing
blade arm
blade
blade arm screws
lock washers
blade
attachment
screws and
washers
plastic
motor
lock
WARNING: To reduce the risk of serious
bodily injury, DO NOT use power tools to
assemble the blades. If screws are
overtightened, blades may crack and break.
Time Saver: Washers for blade screws can be
set on each blade screw prior to installing
blades.
Locate 15 blade attachment screws and
washers in hardware pack. Hold blade arm
up to blade and align holes. Insert 3 blade
attachment screws (along with washers) with
fingers first and then tighten screws securely
with a Phillips screwdriver. Repeat for the
remaining blades.
Remove blade arm screws and lock washers
from underside of motor. If plastic motor
locks are installed with blade arm screws,
discard plastic motor locks (save blade arm
screws and lock washers to secure blade arms).
Align blade arm holes with motor screw holes
and attach blade arm with lock washers and
blade arm screws. Before securing screws
permanently, repeat with remaining blade
arms. Securely tighten all screws.
IMPORTANT: Tighten blade arm screws twice
a year.
Loading ...
Loading ...