Loading ...
Loading ...
Loading ...
10. OPERATING THE PRESSURE WASHER
9.4 ADDING PETROL - FIG.15
9.5 USING PRESSURE WASHER AT HIGH ALTITUDES
FIG.15
WARNING: Petrol and petrol vapour are extremely flammable and explosive. Fire or
explosion from misuse of fuel can cause severe burns and even death. Failure to use
fuel as recommend in this manual will void the warranty.
17
16
9. PREPARING THE PRESSURE WASHER
PRIOR TO STARTING THE PRESSURE WASHER, MAKE SURE THAT YOU HAVE:
1. Selected the proper size nozzle for the job at hand (see “SELECTING THE RIGHT NOZZLE”).
2. Turn the water supply on within 60 seconds of starting the engine.
WARNING: DO NOT run the pump without the water supply connected and turned on. The
pressure water pump must not run dry. Failure to follow this will cause damage that is not
covered by any warranty.
3. For your protection, wear protective saftey glasses (not provided).
4. Move the pressure washer OUTSIDE in a fully VENTILATED area.
5. Place the pressure washer on a FLAT and level surface and close to the working surface. Keep
a minimum of 1.5 metres CLEARANCE on all sides of the engine including top. Face the
engine exhaust outlet AWAY from buildings.
6. To restart the pressure washer, the water pressure in the pressure washer needs to be
lowered; turn the water supply off and pull the lance trigger to remove pressure from the
system. Restart the engine, turn the water supply on and within 60 seconds turn the water
supply on again.
NOTE: Attempting to start the pressure washer
with mains pressure washer ON, will be
difficult. The resistance created because of
pressure in the system may cause damage to
the starting assembly. This is not covered by
any warranty.
7. Slide the fuel valve lever to “ON” position
(right) to allow the fuel to flow to the
engine.
8. Slide the choke lever to “START” position
(left).
9. Turn the engine ON/OFF switch clockwise to
ON position.
10. Point nozzle to a safe direction and squeeze the spray gun trigger to allow for easier
engine start.
11. To start the engine, pull starter cord slowly until resistance is felt, then pull rapidly to avoid
kick back. Repeat until engine starts to run. Release the trigger.
12. Slide choke lever to “RUN” (right) position.
10.1 STARTING
WARNING: Do not leave pressure washer in bypass mode for more than two minutes
at a time. Water temperature inside the pressure pump will rise to a dangerous level
resulting in damage to the internal components of the pump. Failure to follow this
warning will void warranty.
DO NOT run the pressure pump without the water supply connected and turned on.
Damage to the pressure washer resulting from failure to follow this instruction WILL
void the warranty.
ALWAYS wear approved safety glasses when operating pressure washers. Spray can
splash back or propel objects, including incorrectly attached accessories.
Loading ...
Loading ...
Loading ...