Loading ...
Loading ...
Loading ...
• Has the wrong ice been added to the bin? Use only cubes
produced by the current ice maker.
• Has the ice melted around the auger (metal spiral) in the
ice bin? Dump the ice cubes and clean the ice bin.
Cut Hazard
Use a sturdy glass when dispensing ice or water.
Failure to de so can result in cuts.
• Is the ice dispenser stalling while dispensing "crushed"
ice? Change the ice button from "crushed" to "cubed." If
cubed ice dispenses correctly, depress the button for
"crushed" ice and begin dispensing again.
• Has the dispenser arm been held in too long? Ice will stop
dispensing when the arm is held in too long, Wait 3 minutes
for dispenser motor to reset before using again,
The water dispenser will not operate properly
• Freezer door closed completely? Close the door firmly. If it
does not close completely, see "The doors will not close
completely."
• Refrigerator connected to a water supply and the supply
shutoff valve turned on? Connect refrigerator to water
supply and turn water shutoff valve fully open.
• Is the water pressure at least 30 psi? The water pressure to
the home determines the flow from the dispenser. See "Water
Supply Requirements,"
• Kink in the home water source line? Straighten the water
source line,
• New installation? Flush and fill the water system.
• Water filter installed on the refrigerator? The filter may be
clogged or incorrectly installed.
• Is a reverse osmosis water filtration system connected to
your cold water supply? See "Water Supply Requirements"
in either the Installation Instructions or the Use & Care Guide.
Water is leaking from the dispenser
NOTE: One or two drops of water after dispensing is normal.
Cut Hazard
Use a sturdy glass when dispensing ice or water.
Failure to de so can result in cuts.
• Glass not being held under the dispenser long enough?
Hold the glass under the dispenser 2 to 3 seconds after
releasing the dispenser lever.
• New installation? Flush the water system. See "Ice and
Water Dispensers."
• Recently changed water filter? Flush the water system. See
"Ice & Water Dispensers."
The dispenser water is not cool enough
NOTE: Water from the dispenser is chilled to only 50°F (10°C).
• New installation? Allow 24 hours after installation for the
water supply to cool completely.
• Recently dispensed large amount of water? Allow 24 hours
for water supply to cool completely.
• Water not been recently dispensed? The first glass of water
may not be cool, Discard the first glass of water.
• Refrigerator connected to a cold water pipe? Make sure
the refrigerator is connected to a cold water pipe. See "Water
Supply Requirements,"
WATERFILTERCERTIFICATIONS
Stare of Cah fornia
Department o| Itcahh Services
Water Treatment Device
Certificate Number
O3- 1550
I)at_" (_s_'d January 21. 200_
TrademarkJModel De_igllalioll Replacement Element_ Rated ('a_
Whltlpol)l WI'-NL24( NL240 240 gal
400 gal
_le water treatment _levice s Ils_ed on _his e_rtifi_at_ have _dt the testhtg _equffemen_s pursuant to Section
116830 o_ the Health _l_d Satet_ n6do for the follo_in_ h(.alth related contaminants:
Mirrohlological Contamillant_ and I urhlditx Inorgalli_Nadloioglcal ('ontanllnants
Norl_" None
Orl_anic I-'entaminallts
I c.ad
llated _er',Are Flow: t) S gpm
no not use with water chat is microhiologicall_ unsafe or of unknown quality, without adequate disinfection
b¢_r¢ or after the system.
10
Loading ...
Loading ...
Loading ...