Loading ...
Loading ...
Loading ...
16
ELECTRONIC CONTROLS SET-UP INSTRUCTIONS (PD & PN MODELS)
Basic Operation of Commercial Washer
n For additional information, see
www.MaytagCommercialLaundry.com.
IMPORTANT
Electrostatic Discharge (ESD)
Sensitive Electronics
ESD problems are present everywhere. ESD may damage
or weaken the electronic control assembly. The new control
assembly may appear to work well after repair is nished, but
failure may occur at a later date due to ESD stress.
n Use an anti-static wrist strap. Connect wrist strap to green
ground connection point or unpainted metal in the washer.
-OR-
Touch your nger repeatedly to a green earth connection point
or unpainted metal in the washer.
n Before removing the part from its package, touch the
anti-static bag to a green earth connection point or
unpainted metal in the washer.
n Avoid touching electronic parts or terminal contacts; handle
electronic control assembly by edges only.
n When repackaging failed electronic control assembly in
anti-static bag, observe above instructions.
GENERAL INFORMATION
Blank Display
This condition indicates the washer is inoperative.
‘0 Minutes’ showing in display
This condition indicates the washer cannot be operated. Coins
dropped or debit inputs during this condition will be stored in
escrow but cannot be used until normal operation is restored by
opening and closing the door. If a door switch fails, it must be
replaced before normal operation can be restored.
OPTIONSCYCLES
DEEP WATER
POWERWASH
TEMPERATURE
SOIL LEVEL
EXTRA RINSE
NORMAL
DELICATES
NORMAL
ECO
Cold Start (initial use)
Washer is programmed at the factory as follows:
n POWERWASH = 12 min agitation
NORMAL = 9 min agitation
DELICATES = 6 min agitation
NORMAL ECO = 8 min agitation
n NORMAL = 1 rinse and 2 minutes of rinse agitation
POWERWASH = 1 deep rinse with spin-out
DELICATES = 1 deep rinse with spin-out
NORMAL ECO = 1 spray rinse
n NORMAL = $2.00
DELICATES = $1.75
POWERWASH = $2.50
NORMAL ECO = $1.75
Warm Start (after power failure)
After a delay of up to 8 seconds, the washer is restored to
the portion of the cycle that existed at time of the power failure.
To continue the cycle, press START/PAUSE.
Free Cycles
This is established by setting the cycle price to zero. When this
happens, ‘SELECT CYCLE’ will appear and cycle price will show
0.00.
Display
After the washer has been installed and plugged in, the display
will show ‘SYnC’ for a few seconds, then ‘0 MINUTES’. Once
the washer has been plugged in and the washer lid opened and
closed, the display will show the price. In washers set for free
cycles, the display will ash ‘SELECT CYCLE’, and will display
‘PRICE 0.00’.
Loading ...
Loading ...
Loading ...