Loading ...
Loading ...
Loading ...
14
English
Use
Adjusting the support feet
The equipment is equipped with 2 support feet. If the equipment is
not stable, the support feet can be adjusted.
- Turn the support feet as required to put the equipment in a stable
position.
‼ NOTE
• The machine is the most stable when all support feet are turned
fully in. Therefore start to level the machine by turning all
support feet fully in, before turning out the required support
feet to stable the machine.
Adjusting the horizontal seat position
The horizontal seat position can be adjusted by setting the seat to
the required position.
- Loosen the seat adjustment knob.
- Move the seat to the required position.
- Tighten the seat adjustment knob.
Adjusting resistance
To increase or decrease resistance, turn the adjustment knob at
front of the rowing frame cover clockwise (+ direction) to increase
resistance and Counterclockwise (- direction) to decrease resistance.
The scale above the knob (1-8) helps you find and reset a suitable
resistance.
Replacing the batteries (Fig E-2 )
The console is equipped with 2 AAA batteries at the rear of the
console.
- Remove the cover.
- Remove the old batteries.
- Insert the new batteries. Make sure that batteries match the (+) and
(-) polarity markings.
- Mount the cover.
Console (fig E-1)
⚠ CAUTION
• Keep the console away from direct sunlight.
• Dry the surface of the console when it is covered with drops of
sweat.
• Do not lean on the console.
• Only touch the display with the tip of your finger. Make sure that
your nails or sharp objects do not touch the display.
‼ NOTE
• The console switches to standby mode when the equipment is
not used for 4 minutes.
Explanation Display functions
Scan
- Automatically scan functions for : Speed, Distance, Time,
Odometer, Calories & Pulse.
- Each display will be hold ±5 seconds.
Time
- Automatically accumulates workout Time when exercising.
Speed
- Displays current training speed.
Odo
- Automatically accumulates the total distance for all exercise
sessions.
Dist
- Distance for the workout.
Pulse
- Display current heart rate if measured.
‼ NOTE
• Before measuring your pulse rate, please place your palms of
your hands on both of your contact pads and the monitor will
show your current heart beat rate in beats per minute(BPM) on
the LCD after 6~7 seconds.
• During the process of pulse measurement, because of the
contact jamming, the measurement value may be higher than
the virtual pulse rate during the first 2~3 seconds, then will
return to normal level.
• The measurement value cannot be regarded as the basis of
medical treatment.
Cal
- Automatically accumulates Calorie burnt when exercising.
‼ NOTE
• This data is a rough guide for comparison of different exercise
sessions which cannot be used in medical treatment
Explanation of buttons
MODE
- Press MODE button to select console functions; Time, Speed, Dist,
ODO, Cal. & Pulse
- Push and hold for 4 seconds to reset: Time, Count, Dist & Calorie.
‼ NOTE
• Total Count can only be reset by a batteries exchange.
Extra notes
- If the display is faint or shows no figures, please replace the
batteries.
- The monitor will automatically shut off if there is no signal received
after 4 minutes .
- The monitor will be auto-powered on when starting to exercise
push button w/signal in.
- The monitor will automatically start calculating when you start to
exercise and will stop calculating when you stop exercising for 4
seconds .
Loading ...
Loading ...
Loading ...