Frigidaire FGHS2365KF4 Gallery 23 Cu. Ft. Side-By-Side Refrigerator

Use & Care Guide - Page 15

For FGHS2365KF4.

PDF File Manual, 20 pages, Read Online | Download pdf file

FGHS2365KF4 photo
Loading ...
Loading ...
Loading ...
15
CHANGING THE FILTEr
More about your Advanced Water Filter
The PureSource Ultra
TM
ice and water
ltersystemistestedandcertiedbyNSF
International, the nationally respected,
not-for-protcerticationorganizationfor
public health safety. The PureSource
Ultra
TM
iceandwaterltersystemistestedand
certiedtoANSI/NSFStandards42and53forthe
reductionofclaimsspeciedontheperformancedata
sheet.
Do not use with water that is microbiologically unsafe
or of unknown quality without adequate disinfection
beforeorafterthesystem.Systemscertiedforcyst
reduction may be used on disinfected waters that may
containlterablecysts.
Test & certication results:
• RatedCapacity-200gallons/757litersfor
PureSource Ultra
TM
iceandwaterlter
• Ratedserviceow-.50gallonsperminute
• OperatingTemp.:Min.33°F,Max.100°F
• MaximumRatedPressure-100poundsper
square inch
• RecommendedMinimumOperatingPressure:30
pounds per square inch
7 Afterllingoneglassofwater,continueushing
the system for about three minutes.
8 Turn On the ice maker.
9 Press and hold the Filter Status button on the Ice
& Water Dispenser control panel for three seconds.
When the display changes from “replace” to
Good,” the status has been reset.
To replace your PureSource Ultra
TM
water
lter:
It is not necessary to turn the water supply off to change
thelter.Bereadytowipeupanysmallamountsof
waterreleasedduringthelterreplacement.
1 Turn Off the ice maker power switch.
2 Removethelterbypushingontheend/faceof
thelter.
3 Slidetheoldwaterltercartridgestraightoutof
the housing and discard it.
4 Unpackagethenewltercartridge.Usingthe
alignmentguide,slideitgentlyintothelter
housing until it stops against the snap-in connector
at the back of the housing.
5 Push rmly until the cartridge snaps
into place (you should hear a click as the
cartridge engages the snap-in connector).
6 Press a drinking glass against the water dispenser
whilecheckingforanyleaksatthelterhousing.
Any spurts and sputters that occur as the system
purges air out of the dispenser system are normal.
Loading ...
Loading ...
Loading ...